Roll Hill MOONS02 Moonrise Sconce Instruction Manual
- June 10, 2024
- Roll Hill
Table of Contents
MOONS02 Moonrise Sconce
Instruction Manual
CONTENTS
SAFETY INFORMATION
Only suitable for direct mounting on non-combustible surfaces.
Under no circumstances can Moonrise Sconce be mounted on normally flammable
surfaces.
Suitable for dry and damp locations, indoor use only.
Maximum ambient temperature: 25˚C
Moonrise Sconce 02 INSTALLATION
Note: Please contact a licensed electrician for installation. Ensure power is off during installation.
- Detach the crossbar/wall plate (A) from the back of the fixture (B) and secure onto the junction box (C) using provided #8-32 screws (D).
- Ground the fixture (B) using the provided wagon connector (E) with a terminal ring and green ground screw. Make sure to pull out the lead wires through the center hole in crossbar.
- Rotate the cleats (F) and the mating cleats (G) (back of the fixture) to the desired position for vertical or horizontal fixture mounting.
- Carefully hold fixture (B) to crossbar/wall plate (A) and make the lead wire connections with the provided wagon connectors (H). Push all wires back through center hole of crossbar/wall plate (A) into junction box (C).
- Fit the light fixture (B) back over the crossbar/wall plate (A) using the cleats and secure it in place with the two #4-40 5/16in provided screws (I).
For 120V
Note: Please contact a licensed electrician for installation. Ensure power is off during installation.
- Detach the crossbar/wallplate (A) from the back of the fixture (B) and secure onto the wall (C) using provided screws (D) and toggle anchors (E).
- Ground the fixture (B) using the provided wago connector (F) with a terminal ring and green ground screw. Make sure to pull out the lead wires through the center hole in crossbar.
- Rotate the cleats (G) and the mating cleats (H) (back of the fixture) to the desired position for vertical or horizontal fixture mounting.
- Carefully hold fixture (B) to crossbar/wallplate (A) and make the lead wire connections with the provided wago connectors (I). Push all wires back through center hole of crossbar/wallplate (A) into junction box (C).
- Fit the light fixture (B) back over the crossbar/wallplate (A) using the cleats and secure it in place with the two #4-40 5/16in provided screws (J).
For 240V
Updated 22Nov2021
Documents / Resources
| Roll
Hill MOONS02 Moonrise
Sconce
[pdf] Instruction Manual
MOONS02 Moonrise Sconce, MOONS02, Moonrise Sconce, Sconce
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>