BRAINWAVZ Earpad Adapter Ring Installation Guide

**BRAINWAVZ Earpad Adapter Ring Installation Guide

**

Remove Stock Pads

1. Grip the pad firmly with thumbs and fingers.
2. Twist the pad to the right (clockwise) to release the pad from the head unit.

NOTE: The pads are attached to a plastic mounting ring

Get To Know The Adapter Ring

FRONT
There are 3 raised clips A that fit into corresponding holes on each headset

BACK
The smooth back panel sits flat against the inside of your chosen earpad.

Install The Earpads

Slide the adapter into the mounting flap on the rear of the earpad, pull the fabric over so the ring is completely inside the flap

Ensure that the fabric flap does not obstruct any of the mounting clips

Install The Adapter

1. Line up the three clips on the adapter ring A with the three holes on the head unit B , and slot the pad into place.
   Ensure all three clips are in correctly before continuing.
   

2. Grip the plastic ring and pad together and slowly but firmly twist 10 – 15 degrees to the left (counter clockwise).
   

NOTE
Do not over-tighten or you may break the mounting clips.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>