vego garden 17 Inch Tall L Shaped Raised Garden Bed Kit Instruction Manual

: June 5, 2024
: vego garden

Table of Contents

Assembly Guide
Safety Edging
Parts List
Bracing Rod Installation Guide
Configurations
Product Photo
Contact Us
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Tall L-Shaped Raised Garden Bed Kit
Instruction Manual

( Note: This manual is designed for all L•Shaped Raised Garden Bed Kits, and the variety of parts & quantity will vary depending on the model that was purchased )
CAUTION : Please be aware that there are sharp metal edges. The use of protective equipment such as gloves and closed-toe shoes is recommended.
CHOKING HAZARD : Small parts. Keep product away from children.

Assembly Guide

Remove Protective Film

Remove protective films from all panels, and lay panels on a flat surface according to the L-shaped configuration.

Assemble Straight Panels

Cap nuts are used for the top 2 rows, standard nuts are used for the lower 4 rows. Assemble all straight panels: initially attach all washers and nuts loosely, and then tighten up using the included hand wrench and a screwdriver/cordless doll.

Tighten Nuts & Bolts

Make sure to tighten each nut and bolt for reinforcement of the garden-raised bed.

Attach Corner Panels

After straight panels are assembled, attach corner panels to straight panels using the same method. Make sure corner panels are attached to the outside of the straight panels. (Please refer to the Bracing Rod Installation Guide for rod assembly instructions.)

After all straight and corner panels

Attach the angled Joint panel to the straight panels using the same method. Make sure to attach the straight panels outside of the angled joint panel. (Please refer to the Bracing Rod Installation Guide for rod assembly instructions.)

Safety Edging

Push the safety edging down along the top rolled steel edge, covering the perimeter of the bed, and cut on the extra length. Make sure the edging is attached securely.

Complete

Congratulations on completing the assembly! We are sure there are more configurations you can make with your great imagination!

Parts List

(This general manual applies to all Vego Garden-shaped garden beds. The package of a product model may not contain all the parts below. The number of parts for each product model may vary.)

Bracing Rod Installation Guide

Bracing Rods

Vego Garden bracing rods are used to reinforce the structure of oversized raised beds. I r Tall L• Shaped Raised Garden Bed Kits include 2.5ft bracing rods.

Bracing Rod Installation

Install bracing rods in the 4th bolt holes from the top, making sure the rods are in parallel holes. Attach bolt, panel, washer, and rod loosely, then tighten the bolts with the included hand tool for reinforcement.
Note : Bolts and washers used for rod installation are the same as those used to assemble the panels of the raised bed.

Reference Pictures