Lindab SVK Sealing Clamp Instruction Manual

October 30, 2023
Lindab

lindab | for a better climate

Sealing clamp

SVK

Assembly

When installing the duct system leave an opening that is one or more cm longer than the fitting you may want to remove later on.
It is preferable to install the clamp before the fitting, in the direction of air flow, as this increases the likelihood of the fitting not being pushed out at the end, which is only pushed in. In particular, this applies to fittings with a large pressure drop, such as closed dampers. Lindab SVK Sealing Clamp
A1

  1. Duct
  2. Opening
  3. Direction of air
  4. Fitting
  5. Sealing clamp

First install the clamp by inserting it from the side of the opening and then pushing it further along the duct past the end so that the opening remains free.

Lindab SVK Sealing Clamp A2

Then install the fitting by inserting it from the side of the opening and then pushing it in the opposite direction along the duct in the same way. A gap then develops between the fitting and the end of the duct.

Lindab SVK Sealing Clamp A3

  1. Gap

This gap is covered by the clamp by pushing it back a bit. Then lock the clamp by closing the two eccentric locks.

Lindab SVK Sealing Clamp A4

Maintenance

The sealing clamp normally doesn’t requires any maintenance.

2022-06-14

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals