PROAIM P-OHCP-01 3ft Overhead Platform for Camera and Studio Lights User Manual

PROAIM P-OHCP-01 3ft Overhead Platform for Camera and Studio Lights User Manual

What’s In The Box

Please inspect the contents of your shipped package to ensure you have received everything that is listed below.

• 1 x Cross Bar
  

• 2 x Side bar
  

• 2 x Ground Foot
  

• 1 x Camera Mount
  

• 4 x Support bar

• 2 x L Bracket

• 9 x Foot Thumb Screw &
  8 x M5 Short Thumb Screw
  

• 2 x Plastic Clips

All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or transmitted by any form or by any means, electronic, mechanical, photo- copying, recording, or otherwise, except as may be expressly permitted by the applicable copyright statutes or in writing by the Publisher.

3ft Overhead Platform Setup

• Slide and place the side bar on the ground foot. Lock the assembly using 1/4-20 foot thumbscrew.
  

• Side Bar is properly attached to the ground foot.
  

• Attach the support bar on the side bar using the long M5 Short knob.
  

• Then to attach the support bar on the foot, use short M5 short knob.
  

• Repeat these steps for the other support bar assembly, as shown in the image.
  

• Slide the camera holder on the cross bar
  

• Adjust the cross bar height by sliding it along the side bar.
  NOTE: Camera Platform slide on crossbar as per your requirement.
  
  NOTE: The Overhead Platform’s crossbar is up/ down adjustable & easily mounts through rosette knobs. The Camera Holder with a ¼”-20 screw can be locked into any position on the crossbar.
  

• Then lock it into position using the two height adjustment thumb screws.
  

• To secure the cross bar, insert pin on the side.
  

• Secure it from the other side too.
  

• You can adjust the height of the crossbar according to your shooting setup.
  

• Attach two L-brackets using the thumb screws on the cross bar.
  

• Both the L-brackets are properly attached now.
  

• Clamp your backdrop to the brackets using two clips.
  NOTE: The backdrop & other related accessories are not included with the Overhead Camera Platform.
  

YOUR PROAIM 3FT OVERHEAD PLATFORM FOR CAMERA & STUDIO LIGHTS ALL DRESSED UP AND READY TO GO!

Warranty: We offer one year warranty for our products from date of purchase. Within this period of time, we will repair it without charge for labor or parts. Warranty doesn’t cover transportation costs nor does it cover a product subjected to misuse or accidental damage. Warranty repairs are subjected to inspection and evaluation by us.
Liability: We are not liable for damage caused by products that we do not supply or from mishandling in transit, accident, misuse, neglect, lack of care of the product, or service by anyone other than our company.
Contact Us: In case of any kind of dissatisfaction, please Contact us immediately and we promise our utmost support and care until you use our product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>