SERAX B7221181 Marie Michielssen Floor Lamp Earth Instruction Manual

SERAX B7221181 Marie Michielssen Floor Lamp Earth[

](https://manuals.plus/wp- content/uploads/2022/09/SERAX-Marie-Michielssen-Floor-Lamp- Earth.png)Instructions

Luminary specs

• TYPE Floor Lamp
• COLOR Beige

DIMENSIONS

• L70 x W50 H37 cm
• L27 1/2 x W19 5/8 H14 5/8 inch
• SWITCH Footswitch
• CABLE LENGTH 2m

Bulb type E27
Bulb included
Max. 5W
Class II
Supplied

Instruction to install the light bulb into the lamp[

](https://manuals.plus/wp-content/uploads/2022/09/SERAX-Marie- Michielssen-Floor-Lamp-Earth-3.png)

STEP 1: The socket is mounted on a small magnetic plate.

STEP 2: Gently take out the plate with the socket. STEP 3: Turn the bulb into the socket.

STEP 4: Last step, click the plate with the socket back onto the magnetic part inside the lamp.

Safety directions

Please study the instruction manual and below information carefully before installing or using this product. Please keep this user manual for further reference.

1. The luminaires may only be installed by authorized and qualified technicians according the valid regulations for electrical installation.
2. Maintenance of the luminaires is limited to their surfaces. During maintenance no moisture can come into contact with any areas of the terminal connections or voltage control parts.
3. The electrical supply must be switched off at the outset, preferably by means of a switch in the distribution box, before any installation, maintenance or repair work is undertaken.
4. Exterior light must not be installed during rain.
5. Take account of the minimal separation distance from other objects and the room required around the fitting.
6. If in any doubt, consult a professional, taking local installation requirements into account. Some countries stipulate that lighting may be installed only by registered installers.
7. Clamping screws in electrical connections must be adequately tightened. This is particularly the case with 12V low voltage conductors.
8. When replacing a halogen lamp, wait for it to cool, for a minimum of 5 minutes.
9. Clean with a clean, dry cloth or brush, use no solvents or abrasives. Avoid dampness on all electrical components.
10. Take account of all available technical information.
11. Take note of the symbols when connecting wires:
    • N = Neutral
    • L = Live
12. If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
13. Meaning of symbols:
14. For indoor use only, where direct contact with water is impossible
15. Protection class 1: the fitting must be earthed
16. Protection class 2: the fitting is double insulated and does not require earthing
17. Protection class 3: the fitting is low voltage
18. Observe the indicated minimum distance between the lamp and the illuminated materials/objects
19. Only the self-screening halogen illuminants should be used with the luminaire
20. Strip the wire to the indicated length
21. Connect using the specified cable
22. The fixture can be used in combination with a dimmer. Consult the sales outlet for the correct type of dimmer (important in the case of 12V fittings)
23. The maximum wattage indicated in each lighting unit, for example, must not be exceeded
24. This luminaire cannot be disposed together with normal domestic waste in standard rubbish bin, but you have to bring it to a staging area for electrical waste
25. This luminaire was designed to work only with the indicated voltage

WWW.SERAX.COM
Veldkant 21, 2550 Kontich, Belgium – Tel. +32 3 458 05 82

References

• Serax – SERAX

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>