tp-link MC100CM, MC110CS Enlarge Your Ethernet Network Media Converter User Guide
- October 30, 2023
- tp-link
Table of Contents
tp-link MC100CM, MC110CS Enlarge Your Ethernet Network Media Converter
Product Information
The Fast Ethernet Media Converter allows you to enlarge your Ethernet network. This product is compliant with IEEE 802.3, IEEE 802.3i, and IEEE802.3u standards. It comes with LED indicators that show the power status and link/activity status for both the fiber and twisted-pair interfaces. The converter has one SC fiber optic connector and one RJ45 jack connector.
LED Explanation
- PWR
- On: Power on
- Off: Power off
- FX Link/Act
- On: Valid link
- Flashing: Transmitting or receiving data
- Off: Invalid link
- TP-Link/Act
- On: Valid link
- Flashing: Transmitting or receiving data
- Off: Invalid link
Scenario
For MC100CM/MC110CS
-
Scenario 1: Connect Devices with and without Optical Interfaces
-
Scenario 2: Connect Devices without Optical Interfaces
Note:- Please use two Media Converters of the same model to work properly.
- Please connect the TX port of one converter to the RX port of the other using a fiber cable.
For MC111CS/MC112CS
- Scenario 1: Connect Devices with and without Optical Interfaces
- Scenario 2: Connect Devices without Optical Interfaces
Note: Please use one MC111CS and one MC112CS to work properly.
Specifications
General Specifications
- Standards IEEE 802.3, IEEE 802.3i, IEEE802.3u
- LED PWR, FX Link/Act, TP Link/Act
- Connector 1 SC fiber optic; 1 RJ45 jack
- Twisted-Pair
- 10BASE-T: 2-pair UTP/STP of Cat. 3 or above (≤100m)
- 100BASE-Tx: 2-pair UTP/STP of Cat. 5 or above (≤100m)
- Fiber
- For MC100CM: 62.5/125μm multi-mode (≤2km); 50/125μm multi-mode (≤2km)
- For MC110CS/ MC111CS/MC112CS: 9/125μm single-mode fiber (≤20km)
- Wave Length
- For MC100CM/MC110CS: 1310nm
- For MC111CS: 1550nm TX, 1310nm RX
- For MC112CS: 1310nm TX, 1550nm RX
- Power External Power Adapter: 9V/0.6A
Environmental and Physical Specifications
- Operation Temperature 0˚C to 40˚C (32˚F to 104˚F)
- Storage Temperature -40˚C to 70˚C (-40˚F to 158˚F)
- Operation Humidity 10% to 90% RH non-condensing
- Storage Humidity 5% to 90% RH non-condensing
Safety Information
- Keep the device away from water, fire, humidity or hot environments.
- Do not attempt to disassemble, repair, or modify the device.
- Do not use damaged charger or USB cable to charge the device.
- Do not use any other chargers than those recommended.
- Adapter shall be installed near the equipment and shall be easily accessible.
- Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
- Do not point or stare directly into the beam or into the optical port of the transceiver when it is operating, as this can injure your eyesight.
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/30/EU,
2014/35/EU, 2009/125/EC, 2011/65/EU and (EU)2015/863. The original EU
declaration of conformity may be found at https://www.tp-
link.com/en/support/ce/
UK declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of the Electromagnetic
Compatibility Regulations 2016 and Electrical Equipment (Safety) Regulations
2016. The original UK declaration of conformity may be found at https://www
.tp-link.com/support/ukca/
FCC
FCC compliance information statement
Product Name: Fast Ethernet Media Converter
Model Number: MC100CM/MC110CS/MC111CS/MC112CS
Responsible party:
TP-Link USA Corporation
Address: 10 Mauchly, Irvine, CA 92618
Website: https://www.tp-link.com/us/
Tel: +1 626 333 0234
Fax: +1 909 527 6804
E-mail: sales.usa@tp-link.com
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the equipment is properly maintained and operated.
FCC compliance information statement
Product Name: I.T.E. POWER SUPPLY
Model Number: T090060-2B1
Responsible party:
TP-Link USA Corporation
Address: 10 Mauchly, Irvine, CA 92618
Website: https://www.tp-link.com/us/
Tel: +1 626 333 0234
Fax: +1 909 527 6804
E-mail: sales.usa@tp-link.com
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
We, TP-Link USA Corporation, has determined that the equipment shown as above has been shown to comply with the applicable technical standards, FCC part 15. There is no unauthorized change is made in the equipment and the equipment is properly maintained and operated.
Industry Canada Statement
Canadian Compliance Statement
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
CE Mark Warning
This is a class A product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.
Explanation of the symbols on the product label
For technical support and other information, please visit https://www.tp- link.com/support, or simply scan the QR code.
References
- Link: Simple, secure one-click payments
- CE Regulatory Compliance | TP-Link
- TP-Link Product Support - Wireless Networking Equipment Support
- Regulatory Compliance | TP-Link
- WiFi Networking Equipment for Home & Business | TP-Link