FODSPORTS FX30C PRO Helmet Bluetooth Intercom Headset with Camera User Guide
- October 30, 2023
- Fodsports
Table of Contents
FX30C PRO Helmet Bluetooth Intercom Headset with Camera
Product Information
The product operates on a frequency range of 2402-2480MHz and
complies with part 15 of the FCC Rules. It has been evaluated to
meet general RF exposure requirements and can be used in portable
exposure conditions without restriction. Any changes or
modifications not approved by the responsible party for compliance
may void the user’s authority to operate the equipment.
Product Usage Instructions
-
Ensure that the device is fully charged before use.
-
Power on the device by pressing and holding the power button
until the LED indicator lights up. -
Pair the device with your Bluetooth-enabled device by following
the pairing instructions in your device’s user manual. -
Once paired, you can use the device to transmit and receive
audio. -
Adjust the volume using the volume controls on your
Bluetooth-enabled device or on the product itself. -
To power off the device, press and hold the power button until
the LED indicator turns off.
Note: The device must not be subjected to any modifications or
changes not approved by the responsible party for compliance. If
you experience any interference or undesired operation, discontinue
use immediately and contact the manufacturer for assistance.
2402-2480MHz 2402-2480MHz
FCC Caution This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures: -Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver. -Connect the
equipment into an outlet on a circuit different from that to which the
receiver is connected. -Consult the dealer or an experienced radio/TV
technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>