INTELLINET 508827 8-Port Gigabit Ethernet Industrial Switch with 2 SFP Ports Instruction Manual
- June 8, 2024
- INTELLINET
Table of Contents
INTELLINET 508827 8-Port Gigabit Ethernet Industrial Switch with 2 SFP
Ports
register.intellinet-network.com/r/508227
Instructions
The Intellinet 8-Port Gigabit Ethernet Industrial Switch with 2 SFP Ports offers an array of time-saving, cost-effective features while providing superior network throughput. No configuration is required and installation is plug and play.
Features
- Provides RJ45 data connections for up to eight network devices
- IP40 slim-type metal housing to withstand harsh industrial conditions
- Wide operating temperature: -40 – 75°C (-40 – 167°F)
- Option for DIN-rail installation
- Two small form-factor pluggable GBIC module slots (SFP)
- Two redundant DC inputs (12 – 48 V) with I/O terminal block With a backplane speed of 20 Gbps, plenty of performance is available for your computers, servers and other networking devices. Each of the ports automatically senses the link speed of the connected network device and adjusts to 10, 100 or 1000 Mbps for compatibility and maximum performance.
For specifications, visit intellinetnetwork.com. Register your product at register. intellinet-network.com/r/508827 or scan the QR code on the cover.
LEDs
| LED | Color | Status | Status Description |
|---|
PWR
| ****
Green
| On| Power on
Off| Power off
Link/Act 1 – 8 / SFP
1 & 2
| ****
Green
| On| Valid port connection
Blinking| Sending or receiving data
Off| No link established
Cat5e/6/6a UTP/STP cables provide optimal performance; if a status LED doesn’t indicate a link or activity, check the corresponding device for proper setup and operation.
Power
Terminal Block Installation
NOTE: Ensure all power is off/disconnected before beginning!
- Loosen appropriate screws.
- Insert bare power-supply wires into appropriate terminal slots (positive wire into positive slot; negative wire into negative slot).
- Tighten appropriate screws to secure wires. (If desired, repeat steps 1 – 3 on second input pair.)
- Install block into the device and tighten screws.
Power Off Alarm
You can choose whether to connect the power failure warning device to the
connecting terminal marked “Fault” according to your requirements. When using
power redundancy, if one power source fails, a fault alarm will be generated.
Chassis Ground Column
Located on the side of the power supply connector, a grounding terminal
connector is used to provide proper grounding for your Intellinet Network
Solutions switch. If you use the chassis grounding screw, it should be wired
to an object that provides earth ground. In rackmount installations, grounding
is typically provided by the metal frame of the mounting rack.
Placement
Desktop Installation
Prior to use, place/position the switch:
- on a level surface that can support the weight of the switch and that offers at least 25 mm (approx. 1”) of clearance for ventilation;
- away from sources of electrical noise: radios, transmitters, broadband amplifiers;
- within 100 m (approx. 328’) of network devices it’s to be connected to;
- where it cannot be affected by excessive moisture.
DIN-Rail Installation
- With DIN-rail bracket attached to device with screws, angle bracket onto DIN rail.
- Push device in till it clicks into place.
References
- Intellinet Network Solutions - Provider of PoE and Data Center Product
- Intellinet Network Solutions - Provider of PoE and Data Center Product – Intellinet Solutions
- DropCatch.com
- Intellinet Network Solutions Account and Product Registration
- Intellinet Network Solutions Account and Product Registration
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>