hansgrohe Metris Classic Mixers Instruction Manual
- October 30, 2023
- hansgrohe
Table of Contents
- hansgrohe Metris Classic Mixers
- Product Information
- Product Usage Instructions
- Safety Notes
- Installation Instructions
- Technical Data
- Symbol description
- Dimensions
- Flow diagram
- Spare parts
- Special accessories
- Operation
- Cleaning
- Test certificate
- Assembly
- ABOUT COMPANY
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
hansgrohe Metris Classic Mixers
Product Information
The product is a shower system that can be used for bathing, hygiene, and body cleansing purposes. It has a one-hand mixer with a warm water limiter which can be adjusted as per the user’s preference. The shower system can be used with continuous flow water heaters, and a warm water stop valve is not required. The recommended operating pressure is 1.6 MPa with a maximum operating pressure of 1 MPa. The shower system comes with spare parts and special accessories like a special tool (58085000), and an installation kit needs to be purchased separately.
Product Usage Instructions
During installation, it is recommended to wear protective gloves to prevent crushing and cutting injuries. The hot and cold water supply pressures must be equal to avoid any damage. To adjust the hot water limiter on single lever mixers, refer to page 33 of the manual. Do not use silicone containing acetic acid. The shower system should only be used for bathing, hygiene, and body cleansing purposes. Cleaning instructions can be found on page 37 of the manual. To assemble the shower system, refer to pages 31 and 32 of the manual.
Safety Notes
- Gloves should be worn during installation to prevent crushing and cutting injuries.
- The shower system may only be used for bathing, hygienic and body cleansing purposes.
- The hot and cold supplies must be of equal pressu-res.
Installation Instructions
- The fitting must be installed, flushed and tested after the valid norms.
- If the instantaneous water heater causes problems or if you wish to increase the water flow, the EcoSmart® (flow limiter) located behind the aerator can be removed.
Technical Data
This mixer series-produced with EcoSmart® (flow limiter)
-
Operating pressure: max. 1 MPa
-
Recommended operating pressure: 0,1 – 0,5 MPa
-
Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI) -
Hot water temperature: max. 80°C
-
Recommended hot water temp. : 65°C
Hansgrohe mixers can be used together with hydraulically and thermically controlled continuous flow heaters if the flow pressure is at least 0,15 MPa.
Symbol description
Dimensions
Flow diagram
(see page 34 + 35)
- with EcoSmart®
- without EcoSmart®
Spare parts
Special accessories
- special tool (58085000) order as an extra
- Installation kit order as an extra
Operation
Cleaning
The QuickClean cleaning function only needs a small manual rub over to remove the lime scale from the spray channels.
Test certificate
Assembly
ABOUT COMPANY
- Hansgrohe
- Postfach 1145
- D-77761 Schiltach
- Telefon +49 (0) 78 36/51-1282
- Telefax +49 (0) 7836/511440
- E-Mail: info@hansgrohe.com
- Internet: www.hansgrohe.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>