hansgrohe 56029001 Series RainDrain Rock Instruction Manual
- October 30, 2023
- hansgrohe
Table of Contents
56029001 Series Rain Drain Rock
Instruction Manual
Safety Notes
Gloves should be worn during installation to prevent crushing and cutting injuries’.
Installation Instructions
- Suitable for renovation work and new buildings
- The product should only be installed by specialist companies in compliance with the building regulations.
- To achieve the best possible result, please read the installation guide carefully.
- Before starting the installation, the installation instructions with their specifics should be discussed with the tiler. Please hand all installation instructions to the tiler after installation.
- Prior to installation, inspect the product for transport damages. After it has been installed, no transport or surface damage will be honored.
- When using the drain in conjunction with several showers, please check if the draining capacity of the drain is adequate.
- We recommend taping off the drain opening of the drain set or closing it with the cement cap before installation to prevent construction debris from getting into the drain pipe.
- To prevent damage to the tile frame, it should be kept infits packaging until final installation by the tiler.
- Align the drain horizontally in all directions.
- The installation of the waste water system must be carried out in accordance with the standards. Pay attention to adequate aeration and ventilation, and an adequate slope in the waste water system.
- Check the drain system and the waste water connections for tightness.
- To prevent any cavities, the drain body must be fully lined and compacted with screed up to the top edge of the flange.
- When laying the floor tiles, the tile slope (min. 2%) in the shower area must always slope towards the drain. The tiles must be laid flush or 1 mm higher than the top edge of the tile frame. This ensures good drainage towards the drain set. Other requirements regarding the slope may apply for floor-level showers with glass walls. The manufacturer’s specifications must be observed.
- After tiling, the transition between the tiled floor and the drain must be sealed with a permanently elastic joint (maintenance joint). The bonding surfaces must be free of mortar, adhesive and other adhesion-inhibiting materials.
- The drain is only suitable for normal domestic waste water. Avoid other liquids as well as cleaning agents that can damage sanitary fitments, draining facilities and pipe materials.
- When using the drain in other areas (e.g. swimming pools) where the drain may come into contact with aggressive cleaning agents or corrosive substances such as salt or chlorine, please contact the manufacturer.
- Compliance with this installation recommendation is required to make any warranty claims based on our terms and conditions of sale and delivery.
- Products containing chlorine or acids, such as cement residue remover or similar, often contain aggressive chemicals. These can corrode the surface of the product. Bleaches or silver cleaning agents are also unsuitable for stainless steel care. When using tile and joint cleaners, the product must subsequently be cleaned with adequate amounts of clear water. The product cannot be cleaned with abrasive cleaners and / or pointed or abrasive objects. Clean brushed or ground surfaces always parallel to the grind instead of across it.
Symbol description
| Do not use silicone containing acetic acid!
---|---
| Dimensions (see page 5)
| Cleaning (see page 14)
- Before cleaning, remove all parts of the siphon and clean them separately using only mild detergents.
| Spare parts (see page 15)
---|---
Rain Drain Rock
56029001/56030001/56031001/56032001/56033001/56034001/56114001
Sealing advice – primary drainage – clamp drain
- Modulo drain body
- Grate with tile
- Strainer
- Elastic sealant
- Tiles
- Thin set tile adhesive
- Grout
- Pre-assembled waterproofing membrane
- Thin-set sheet membrane (entire floor!)
- Sloped mortar bed – first layer
- Sloped mortar bed – second layer
- Pan liner / Moisture resistant material
- Pea Gravel
- 2” Clamping drain base*
- 2” Clamping ring*
- 2” Rubber sealing gasket
- Sealant between membrane & mortar
- Drainage pipe
*Not included with the drain.
- Modulo drain body
- Grate with tile
- Strainer
- Tiles
- Thin set tile adhesive
- Grout
- Pre-assembled waterproofing membrane
- Thin-set sheet membrane (entire floor!)
- Sloped mortar bed – first layer
- Sloped mortar bed – second layer
- Pan liner / Moisture resistant material
- Pea Gravel
- 2” Clamping drain base*
- 2” Clamping ring*
- 2” Rubber sealing gasket
- Sealant between membrane & mortar
- Drainage pipe
Sealing advice – primary drainage – no-hub sleeve
- Modulo drain body
- Grate with tile
- Strainer
- Elastic sealant
- Tiles
- Thin set tile adhesive
- Grout
- Pre-assembled waterproofing membrane
- Thin-set sheet membrane (entire floor!)
- Sloped mortar bed
- No-Hub sleeve*
- Drainage pipe
- Modulo drain body
- Grate with tile
- Strainer
- Tiles
- Thin set tile adhesive
- Grout
- Pre-assembled waterproofing membrane
- Thin-set sheet membrane (entire floor!)
- Sloped mortar bed
- No-Hub sleeve*
- Drainage pipe
| 
---|---
www.hansgrohe.com/cleaning-recommendation| www.hansgrohe.com/cleaning-
recommendation
|
www.hansgrohe.com/cleaning-recommendation| www.hansgrohe.com/cleaning-
recommendation
Hansgrohe · Auestraße 5 – 9 · D-77761 SciTech ·
Telecon +49 (0) 78 36/51-1282 · Telefax +49 (0) 7836/511440
E-Mail: info@hansgrohe.com · Internet:
www.hansgrohe.com
2022-07-21 90810521 AA023
Documents / Resources
|
hansgrohe 56029001 Series RainDrain
Rock
[pdf] Instruction Manual
56029001, 56030001, 56031001, 56032001, 56033001, 56034001, 56114001, 56029001
Series RainDrain Rock, 56029001 Series, 56029001 Series Rock, RainDrain Rock,
RainDrain, Rock
---|---
References
- Taps for bathrooms, showers and kitchens | hansgrohe INT
- Taps for bathrooms, showers and kitchens | hansgrohe INT
- hansgrohe.com/cleaning-recommendation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>