COSTCO 2323030 Recycling Motion Sensor Can Instructions

: October 30, 2023
: Costco

Table of Contents

Product Introduction
Power Supply
Power ON/OFF
Changing Trash Bag
Attention
Trouble Shooting
Battery and Safety Instructions
Not covered by warranty
Customer service
Documents / Resources

**COSTCO 2323030 Recycling Motion Sensor

**

IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY

Product Introduction

Sensor panel
Plastic bag stabilizer
Inner bucket A
Inner bucket B
Handle
Body B
Foot pedal
Flap
Lid
Handle
Body A
Sensor panel
Battery box
Power switch

Power Supply

Turn to the bottom of the lid, press down and slide open the battery box cover.

Insert 4 AA alkaline batteries according to directions in the battery box.

Do not use rechargeable batteries.
4 AA alkaline batteries not included.

Power ON/OFF

Turn the power switch on, Click “I” to power ON, click “O” to power OFF.

Sensor panel lights up to signal power on.

The middle indicator light flashes about every 6 seconds indicating sensor function is activated.

Sensor Mode

Place hand or object 0-20(±5)cm directly above the sensor panel to open the bin. All LED signal lights will turn on.

5 seconds automatic countdown close: LED signal lights count down 5 seconds before the bin automatically closes.
0-20(±5)cm

Stay Open

Keep hand or object within the sensor range to keep bin open, or use touch buttons to operate the bin.

Manual Mode

Lightly press ” ” to keep the lid open
Lightly press ” ” to close the bin

*Please do not flip or slam the lid by hand to avoid damages to the mechanism.

Deodorizer compartment

Deodorizer compartment is located at the front inner side of the lid. Open the cover of deodorizer compartment, insert deodorizer into the compartment, then close the cover.

*Deodorizer not included

Changing Trash Bag

Depending on waste sorting and recycling needs, use with or without bag.

Pull up and tighten the drawstrings, then remove bag.

Replace the bag and insert excess bin bag into the bag fixer on the inner bucket.

Place the lid back on top of the bin.

Attention

When installing batteries, please mind the battery polarity.
Avoid use under long exposure to direct sunlight and humidity.
Avoid manual force on the bin’s lid during operation.
Wipe lid with clean dry cloth and do not clean with running water.
If lid contacts water, remove the battery compartment cover and air dry the lid before use.
Avoid pressure on the lid and repeated flipping of the lid.
Replace batteries timely when low power signal is on.
Keep sensor panel clean for optimal use.
Keep away from heat, wind sources and high traffic areas.
Do not mix old and new alkaline batteries and do not use rechargeable or acid-based batteries.
Please do not disassemble or attempt repair of the product on your own.

Trouble Shooting

No lights on – Please make sure the batteries are installed correctly or try new batteries
No response from sensor – The lid may have been closed by hand in manual mode. Pressing ” ” will reset the modes.
Sensor lid does not open fully – Indicates low power, please replace batteries with 4 new AA alkaline batteries.

Battery and Safety Instructions

Only adults should handle batteries.
Always use the correct type of batteries (AA alkaline batteries).
Always use all new batteries.
Do not use rechargeable batteries.
Do not mix old and new batteries, or batteries of different types.) When batteries of different brand or type are used together, or new and old batteries are used together, some batteries may be over-discharged due to a difference of voltage or capacity. This can result in venting, leakage, and rupture and may cause personal injury.）
Remove batteries from equipment which is not to be used for an extended period of time.
For recycling and disposal of batteries, please check and comply with your local regulations.

Not covered by warranty

Damages due to user mishandling or other than its intended use in a typical household.
Damages due to natural disasters such as fire, earthquake, flood and other Force Majeur events.
Damages including dents, scratches, and water damage due to transport handled by the user.
Any modification to the product, including disassembly or attempts to repair by the user.
Intentional damage to the product.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Customer service

support@ekousaltd.com

1-800-354-5605 (24-hour hotline, English only)

Distributed by:
Costco Wholesale Corporation
P.O. Box 34535
Seattle, WA 98124-1535
USA
1-800-774-2678
www.costco.com

Made in China

Documents / Resources

| COSTCO 2323030 Recycling Motion Sensor Can [pdf] Instructions
2323030 Recycling Motion Sensor Can, 2323030, Recycling Motion Sensor Can, Motion Sensor Can, Sensor Can, Can
---|---