Kosnic LDG10-BLK Recessed LED Brick Light Ledge Instruction Manual
- October 30, 2023
- Kosnic
Table of Contents
Kosnic LDG10-BLK Recessed LED Brick Light Ledge
Safety Information
- Installation must be carried out in accordance with national building and wiring regulations. If you are in any doubt about installing this product, please consult a qualified electrician.
- Before commencing installation or any maintenance, turn off and isolate the circuit to be worked on by removing the fuse or switching the circuit breaker off at the distribution board.
- This product is suitable for connection to a 110- 240Vac 50/60Hz supply.
- If connecting the luminaire to independent sensors or time switches, ensure that the control device does not leak a voltage across the luminaire in the off state. Leaked voltages may accumulate and cause intermittent flashes in the off state.
- Do not carry or transport product by the supply cable, damage to product mat occur and will invalidate any warranty.
- Seek assistance when handling bulky or cumbersome items.
- Ensure appropriate protective equipment is worn during installation.
- When drilling holes take care not to damage existing wiring or pipework.
- The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced. The construction of this product is such that attempting to remove the light source from within is likely to damage the product functionality, damage the IP rating, lead to premature failure of the product and will invalidate any warranty
Light Source Information
This product contains a light source of energy class E.
The light source is defined as the LED module.
Notes for disassembly and disposal at end of product life:
At the end of product life, the product should be disconnected from the mains
supply by a suitably qualified person and dismantled into its constituent
parts prior to disposal. Only commonly available tools* such as screwdrivers,
knives, soldering irons, spanners, pliers etc should be used and appropriate
safety measures taken during their use. Parts such as
LED strips, LED panels, electrical control gear, wiring, plastic diffusers,
metal components such as back plates or heatsinks should all be separated from
the product and disposed of via appropriate waste streams. Please consult your
local authority for WEEE recycling and disposal options.
*List of commonly available tools is not comprehensive, if in any doubt please contact Kosnic
Installation Instructions
Disposal of the product and packaging materials must comply with French decree No. 2021-835 (France only)
The Waste Electrical & Electronic Equipment Regulations (WEEE) require that products bearing this symbol must not be disposed of with household waste as they may contain substances harmful to the environment. The Local Authority can provide advice on recycling.
References
- Kosnic: New age of lighting - Designers and manufacturers in LED Lighting
- Kosnic: New age of lighting - Designers and manufacturers in LED Lighting