PYLONTECH US3426 Battery Rack Instruction Manual
- October 30, 2023
- PYLONTECH
Table of Contents
PYLONTECH US3426 Battery Rack Instruction Manual
Assembly Instructions
Tools Needed – M5 Allen & Phillips Screwdriver
-
Attach the adjustable feet to the underside of the Bottom panel (G3)
-
Position side panels (#2) on top of the bottom panel. The numbers on the side panels should face the back.
-
Align the top panel (61) so all sides are flus
-
lide the frame on the front so that it covers the bottom, sides, and top panel. Use the fasteners to keep in place – loose fit.
-
slide the back panel on the front so that it covers the bottom, sides, and top panel. The number 4 should be at the bottom. Use the fasteners to keep in place – loose fit.
-
Once all the panels are in position, Fasteners can be tightened.
-
Insert the left 8. Inset the power rails — internals (46 & #5). The F no fasteners needed bottom of the part slides through the slots on the side and bottom panel. Use the fasteners to attached the part at the top. Repeat for the right- hand internals.
-
set the power rails — internals (46 & #5). The F no fasteners needed.
-
Door – Slide the pin of the door into the available hole on the bottom panel. pull the spring catch at the top to position the door.
Please visit www.interactiveit.co.za for an assembly video or follow the instructions below.
Dimensions
UsS3426 Front
US3426 Side
WARRANTY SERVICE
LIMITED WARRANTY
FOR ONE YEAR from the date of purchase from the supplier, this product is warranted against any defects in material or workmanship.
In the event of a warranty claim, an invoice from the supplier is required, a defective part will be replaced free of charge by the manufacturer.
If a replacement part is unavailable, the product will be replaced with one of equal value.
This warranty does not apply to a product that is damaged or altered through transportation, misuse, abuse, corrosion, accident, neglect, modification or mishandling.
3 cabinets stacked at most, largest cabinet at the bottom. Any damage due to over stacking will not be covered by warranty.
Please send any warranty queries together with a copy of your invoice to.