KOAMTAC KDC470 General Universal SmartSled Instruction Manual
- October 30, 2023
- KOAMTAC
Table of Contents
KOAMTAC KDC470 General Universal SmartSled Instruction Manual
What’s in the box?
- 1 x General Universal SmartSled
- 1 x Magnetic OTG USB Connect Head (Type C)
Additional Accessories
- 1-Slot Charging Cradle
- 4-Slot Charging Cradle
- HF Companion
- 0.5W UHF Companion
- 1.0W UHF Companion
- Pistol Grip
- Extended Battery
Assembly Instructions
-
Attach the OTG USB Connect Head to the phone. (A)
-
Check the pin arrangement as shown in the image below because the OTG USB Connect Head is direction-sensitive.
-
Slide the phone into the General Universal SmartSled. (B)
-
Inspect the connection between the General Universal SmartSled and previously installed OTG USB Connect Head. To test the connection, attempt to charge your device via USB or Charging Cradle – the device will begin charging if the connection is successful. (C)
Removing Phone
Remove the phone from the case by peeling off the top edge of the General
Universal SmartSled. Carefully slide the phone up and pull the phone upward.
Remove the OTG USB Connect Head from the bottom of the phone. (D)
USB Port Usage
There is one Micro USB port on the side of the KDC470/475 and one Micro USB
port on the bottom of the General Universal SmartSled. Data communication is
specific for these ports.
*Both USB ports support KDC470/475 and phone simultaneous charging
116 Village Blvd, Ste 305, Princeton, NJ 08540
+1 609-256-4700 I +1 609-228-4373
info@koamtac.com
www.koamtac.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>