chicco Bravo Quick-Fold Stroller Owner’s Manual
- October 30, 2023
- chicco
Table of Contents
chicco Bravo Quick-Fold Stroller Owner’s Manual
WARNING
Failure to follow all warnings and instructions may result in serious injury
or death. For your child’s safety, read the labels and owner’s manual before
using the product.
- PLEASE SAVE OWNER’S MANUAL FOR FUTURE USE.
- ADULT ASSEMBLY REQUIRED.
- NEVER LEAVE CHILD UNATTENDED. Always keep child in view while in the stroller.
- AVOID SERIOUS INJURY from falling or sliding out. Always use seat belt. After fastening buckles, adjust belts to get a snug fit around your child.
- AVOID FINGER ENTRAPMENT: Use care when folding and unfolding the stroller. Be certain the stroller is fully opened and latched before allowing your child near the stroller.
- USE OF THE STROLLER with a child weighing more than 50 lbs (22.7 kg), will cause excessive wear and stress on the stroller. Use the stroller with only one child at atime.
- STROLLER TO BE USED only at walking speed. Product not intended for use while jogging, skating, etc.
- TO PREVENT A HAZARDOUS, UNSTABLE CONDITION, never place purses, shopping bags, parcels or accessory items on the canopy or handle. Do not place more than 10 lbs (4.5 kg) in the storage basket.
- DO NOT use storage basket as a child carrier.
- Avoid burns. Never put hot liquidsin cup holder. Do not place more than 3 lbs (1.4 kg) on the parent tray/cup holder.
- NEVER ALLOW YOUR STROLLER to be used as a toy.
- DISCONTINUE USING YOUR STROLLER should it become damaged or broken.
- AVOID STRANGULATION. DO NOT place items with a string around your child’s neck, suspend strings from this product, or attach strings to toys.
- NEVER USE STROLLER ON STAIRS or escalators. You may suddenly lose control of the product and your child may fall out. Also, use extra care when going up or down a step or curb.
- Do not attempt to attach any infant car seat to the stroller other than a Chicco infant carseat. Injury or death may resultwhen attempting to use this stroller in conjunction with infant car seats from other manufacturers.
- Before use, remove and dispose of all plastic bags and packaging materials and keep them out of reach of children
WARNING
Failure to follow all warnings and instructions may result in serious injury
or death. For your child’s safety, read the labels and owner’s manual before
using the product.
- Before assembly, check that the product and all of its components have not been damaged during transportation.
- Do not use accessories, spare parts, or any component not supplied or approved by Chicco as they may make the stroller unsafe. Using Chicco Infant Car Seat with stroller:
- Child’s Tray must be properly attached to use a Chicco infant car seat.
- ONLY USE a Chicco infant car seat with this stroller.
- Only use this product to transport infants that are within the size and weight limitations of the infant car seat.
- FALL HAZARD: Always check that infant car seat is securely attached to stroller frame by pulling up on the infant car seat.
- ALWAYS SECURE your child with the car seat harness. Always make sure child is properly harnessed in the car seat.
- Refer to your Chicco infant car seat owner’s manual for additional warnings and use instructions before using this product.
Components
A. – Stroller Frame
B. – Front Wheels
C. – Rear Wheels
D. – Rear Axle Assembly
E. – Washers
F. – Pins
G. – Hubcaps
H. – Child’s Tray
How to Assemble Stroller
WARNING
When opening the Stroller, ensure that your child, or other children, are at a
safe distance. Ensure that during these operations, the movable parts of the
Stroller do not come into contact with your child.
If you have hardwood floors or linoleum you may want to perform this step on carpeting or lay down some protection for your floors.
-
A. Stand the Stroller Frame (A) on end and unfold the frame as shown.
1B. Press down FIRMLY on the seat to make sure that the frame is locked.
-
Attach the Rear Axle Assembly (D) to the Stroller Frame, as shown. The Rear Axle Assembly is attached when the snap buttons click into the holes on the Rear Axle mount.
-
A. On one side of the Rear Axle, slide a Rear Wheel (C), and turn the Wheel until the brake tab fits into one of the grooves on the Wheel.
3B. On the same side, slide a Washer (E) onto the Rear Axle.
3C. Secure the Wheel to the Rear Axle using a Pin (F). Push the straight side
of the Pin through the hole on theRear Axle. The curve on the Pin must curve
around the outside of the Rear Axle, as shown. Make sure Washer is between the
Pin and Wheel. Repeat Steps 3A-3C for other side.
3D. Line up the tabs on the Hubcaps (G) with the holes on the Wheel. Snap the
Hubcap onto the Wheel to cover the Washer and Pin. Repeat Step 3D for other
side. Pull on each Wheel to make sure the Wheel assembly is securely attached
to the frame.
-
Attach the Front Wheel (B) to the Stroller Frame by lining up and inserting the Front Wheel Pin into the corresponding opening on the StrollerFront Leg, as shown. Repeat for the other side. Make sure both Wheels are secure by pulling down on Wheel assemblies
How to Adjust the Handle -
Rotate the Parent Handle up from the closed position until it locks into the 1st position. The Parent Handle height can be adjusted to 3 positions, as shown. Push in on both side Buttons to release the Parent Handle. Then rotate the Parent Handle up or down to the desired position.
How to Recline the Seat
-
To Recline the Backrest, squeeze both levers together and pull down on the Backrest. To adjust the Backrest into an upright position, push up on the Backrest until it locks into the desired position.
How to Use the Canopy -
Pull the front edge of the Canopy forward to open the Canopy. Extending to last panel reveals mesh window. Reverse this step to close the Canopy
How to Use the Brakes
-
Push down on the Brake Lock Levers located on each side of the Rear Wheel assembly, to lock the Rear Wheels.
8B. Pull up on the Brake Lock Levers to unlock the Rear Wheels.
How to Use Safety Harness -
A. The Shoulder Straps can be adjusted to 3 height positions as shown. To adjust the Shoulder Harness, pull the strap through the correct buttonhole. Always use the same buttonhole height for both straps (9B).
-
This stroller has a 5-point safetyharness. The Shoulder Strap Connector is designed to break away from the Waist Clip when not secured in the Crotch Strap Buckle. Make sure the Shoulder Strap Connector is in the correct position, as shown. Slide the Shoulder Strap Connector onto the Waist Strap Clip and repeat for the other side. Then slide both Waist Clips into the CrotchStrap Buckle, as shown. Pull on both sides to make sure the Clips are secured to the Buckle.
-
The Safety Harness can be released by pressing the button on the center of the Buckle and pulling both Waist Clips out. Pull up on the Shoulder Strap Connector to remove it from the Waist Strap Clip.
-
The length of the Shoulder Straps can be adjusted by pulling on the adjustment buckles to tighten or loosen. The length of the waist straps can be adjusted. Press the tab at the end of the Waist Strap Clip and pull on the strap to tighten or loosen, to better fit your child.
How to Use the Child’s Tray -
A. Insert the Child’s Tray (H) Tongues into the corresponding openings on the Stroller Frame. To release the Child’s Tray, press in onthe buttons located at the sides of the Child’s Tray, as shown (13B).
How to Use the Basket -
A. Inside the Basket on the back panel, locate 2 storage pockets.
14B. To access the Basket from the front of the Stroller, locate and lift up on the Footrest Pad, as shown.
How to Use the Accessory Pocket -
To access the Accessory Pocket, lift up on the front edge and undo the hook and loop fastener.
How to Remove the Accessory Pocket -
To remove the Accessory Pocket, flip out the plastic tab from the groove under the front of the Parent Tray
-
Pull the Accessory Pocket out ofthe opening on the Parent Tray.
17B. Locate 3 fabric tabs on the bottom of the Parent Tray. Thread the fabric tabs up through the opening that they are threaded through.
17C. Pull up on the Accessory Pocket to remove it from the Parent Tray
Using the Chicco Infant Car Seat -
With the Child’s Tray attached and the Stroller Backrest FULLY RECLINED, place the Chicco infant car seat into the Stroller Frame. The car seat will only fit into the frame “REAR FACING ONLY”. The baby will be facing you when pushing the stroller. Make sure infant car seat clicks into the stroller frame on both\ sides.
Note: Pull up on the infant car seat; make sure it is secured to stroller frame (18B). If using the Canopy with the infant car seat rotate the handle down to allow the Canopy to fully extend open
-
Squeeze the Release Handle on the back of the infant car seat and lift up on the carrying handle, to remove the infant car seat.
How to Remove Front Wheels -
Remove the Front Wheels by pushing in on the Release Button, just above the wheel (as shown). And, at the same time, pull the Front Wheel off of the Stroller Frame. Repeat for the other side.
How to Close the Stroller
-
If attached, remove the infant car seat. Lift up the Seat Fabric and locate the Fold Handle, as shown. Slide the Handle Release buttonover and lift up on the Fold Handle.
-
Pull up on the Fold Handle, the Stroller Legs and Seat back will fold down and the front wheels will automatically swivel. The closed Stroller will now stand on its wheels.
Note: The Fold Handle also acts as a carry handle for the closed stroller.
How to Remove the Seat -
Pull the Canopy Zipper up and around the outside of the Canopy, as shown. Then, pull out on the Canopy Clips to remove the Canopy from both sides of the Stroller Frame.
Note: It is not required for the Canopy to be removed to use Stroller in Car Seat Carrier Mode.
-
Locate the Fabric Clips on both sides below the Parent Tray (as shown). Press down on the Fabric Clip release button, and at the same time pull out the Fabric Clip from Stroller Frame. Repeat for the other side.
24B. The fabric will still be attached to the Parent Tray, as shown. Lift up and remove the Flexible Tab from the groove on the Parent Tray. Fold the Flexible Tab and Fabric Clips forward.
-
Lift up the Footrest Pad on the front of the stroller to locate two sets of straps. Both Straps have a Buckle under the Seat Pan. Reach under the Seat Pan and undo both Buckles
-
Locate two Release Buttons at the back of the Seat. Press both Buttonstogether and at the same time tilt up. Remove the back section of the Seat Pan and Seat Pad Assembly.
How to Use Car Seat Carrier Mode -
To use the Stroller as a Car Seat Carrier without the Stroller Seat attached, follow Steps 18 thru 19 to attach the Chicco infant car seat to the Stroller Frame.
Note: Stroller Canopy can be used in this Mode for additional coverage of the infant.
How to Attach the Seat -
Fold the bottom of the seat pad up to expose Seat Bracket. From the back of the stroller, insert the seat between the stroller frame and tilt the Seat Bracket to line up the tabs with the corresponding openings on the Seat Pan.
28B. Slide the tabs into the openings, to reattach the Stroller Seat .
28C. Press down on the back edge of the Seat Bracket until it clicks into place, making sure both sides lock into the Stroller Frame. Then repeat steps 23-25 in reverse
Cleaning and Maintenance
This product requires regular maintenance. The cleaning and maintenance of the stroller must only be carried out by an adult.
CLEANING
Please refer to the care label for instructions on cleaning the fabric parts
of the stroller. Periodically wipe clean plastic parts with a soft damp cloth.
Always dry the metal parts to prevent the formation of rust if the stroller
has come into contact with water.
MAINTENANCE
Lubricate the moving parts only if necessary, with a light application of a
silicone based lubricant. Periodically check the condition of the wheels, and
keep them clean of dust and sand. To avoid friction that may prevent the
correct operation of the stroller, ensure that all the movable plastic parts
placed along the metal frame are clean of dust, dirt or sand. Keep the
stroller in a dry place. Prolonged exposure to direct sunlight may cause the
fabric to fade.
For More Information
If you have any questions or comments about this product, or are missing any of the parts please do not return this product to the store. Contact us in one of the following way
Tel: (877)-424-4226
Email: info.usa@artsana.com
Add: 1826 William Penn Way Lancaster, PA 17601
Web: www.chiccousa.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>