MOTOBILT MB5013-A JKU Fuel Tank and Skid for Back Half Kit Instruction Manual

: October 30, 2023
: MOTOBILT

Table of Contents

MOTOBILT MB5013-A JKU Fuel Tank and Skid for Back Half Kit
Product Information
Product Usage Instructions
PARTS AND TOOLS
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

MOTOBILT MB5013-A JKU Fuel Tank and Skid for Back Half Kit

Product Information

MB5013 – Assembly Instructions JKU Fuel Tank & Skid for Back Half Kit
The MB5013 is a fuel tank and skid assembly kit designed for the Jeep Wrangler JKU back half kit. The kit includes the following components:

MB5013-A Tank Weldment – Qty 1
MB5013-B Skid Weldment – Qty 1
MB5013-08 Barbed Hose Fitting – Qty 2
MB5515-02 Roll Over Valve – Qty 1
Rubber Bumper – Qty 3
Hex Bolt, Flat Washer, Nylock Nut – Qty 4 each
Hex Bolt, Flat Washer – Qty 7 each
Lock Washer, Hex Bolt, Flat Washer – Qty 8 each
MB5015 Fuel Pump Extension Rod – Qty 2
E-Clip, Countersunk Screw, Flat Washer – Qty 4, 3, and 1
respectively
Rubber Strip – Qty 2
Primary Wire, Black and Red – Qty 1 each
Butt Connector, Pink – Qty 4

Product Usage Instructions

The MB5013 fuel tank and skid assembly kit is designed for use with the Jeep Wrangler JKU back half kit. Follow the instructions below to assemble the kit:

Start by assembling the tank weldment (MB5013-A) and skid weldment (MB5013-B) using the hex bolts, flat washers, and nylock nuts provided. The assembly should be tightened securely.
Attach the barbed hose fittings (MB5013-08) to the tank weldment using the provided hex bolts, flat washers, and lock washers. Tighten securely.
Install the roll over valve (MB5515-02) onto the tank weldment using the countersunk screws and flat washers provided. Tighten securely.
Attach the rubber bumpers to the skid weldment using the hex bolts, flat washers, and lock washers provided. Tighten securely.
Install the fuel pump extension rods (MB5015) onto the tank weldment and skid weldment using the hex bolts, flat washers, and nylock nuts provided. Tighten securely.
Attach the rubber strips to the skid weldment using the hex bolts, flat washers, and nylock nuts provided. Tighten securely.
Connect the black and red primary wires to the fuel pump using the provided butt connectors. Ensure that the connections are secure.

For further assistance with installation or usage of this product, please contact motobilt.com at 334-219-2333.