FENGMA Single 1:14 Twelve Channel Stunt Twisting Remote Control Car Instructions
- October 30, 2023
- FENGMA
Table of Contents
INSTRUCTIONS
Thank you for using our company’s toy products. In order to have a better understanding of this product, please read the following instructions before use, which will bring you a different operating experience.
NOTE
This product is suitable for Children 8 years old and above. After assembled / charged by adults, play with children again.
Please Use This Product Under The Supervision Of An Adult.
Warning: please do not disassemble or modify the product without authorization, any changes may cause the product to not work properly.
SPECIAL WARNING:
The output voltage used by the charging plug should be 5V. Please do not use the quick-charging plug and quick-charging cable, so as to avoid the condition that the too quick current output during charging causes overheated battery charging and results in dangerous matters such as product burnout.
Product Configuration
R/C Car
Handle Remote Control
Rechargeable battery pack
USB Charging Cable
Gravity induction watch R/C (either-or)
3V CR2032 button battery Figure
USB Charging Cable
Built in 3.7N/ lithium battery
Car Batter Installation
- ON/OFF
- Rechargeable battery pack
Battery installation
Open the body battery cover, Connect the rechargeable battery pack to the
power socket Close the battery rover
Battery Charging Mode
A USB Charging Cable
B Rechargeable battery pack
- Connect the Rechargeable battery pack to the USB charging cable
- Plug the other end of the USB charging cable into the USB port for charging
R/C Function introduction and battery installation
-
Demo
-
Deformation
-
Forward
Backward -
Left Transverse
-
Left 45°
-
Indicator Light
-
ON/OFF/Lights
-
Right 45°
-
Turn Left
Turn Right -
Right Transverse
-
360° Rotate
-
Music/ Atomizing
Indicator Light
| When the frequency is not correct, the light flashes, and when the frequency
is up, the light goes out.
---|---
ON/OFF/Lights
| Long press to turn the power on or off; Briefly press to turn on or off the roof lights and light switch.
Left 45°
| When the R/C car is in the stop state, press down the “Left 45° Travel” key, the R/C car travels left 45°.
Right 45°
| When the R/C car is in the stop state, press down the “Right 45° Travel” key, the R/C car travels Right 45°.
Left Transverse
| When the R/C car is in the stop state, press down the “Left Horizontal Travel” key, the R/C car travels left horizontal.
Deformation
| When the remote control vehicle is in a stopped state, press the “deformation” button, and the vehicle body will twist and arch up; Press the button again to lower the vehicle body in parallel.
Right Transverse
| When the R/C car is in the stop state, press down the “Right Horizontal Travel” key, the R/C car travels Right horizontal.
Demo
| Press the “Demo” button when the remote control vehicle is stopped, and the remote control vehicle enters the automatic demonstration mode; Press any key to exit the automatic presentation mode.
Music/Atomizing
| Turn on the phone to tune up, the engine sounds (default), press the first music, press the second or third music, and press the fourth time to turn off the music. Press and hold the button to turn on the atomization function, and the atomization lamp will flash. Turn off the atomization function, and the atomization lamp will go out.
360° Rotate
| When the R/C car is in the stop state, press down the “360° Rotation” key, the R/C car rotates 360°.
Forward/Backward
| Push the forward and backward control lever of the remote controller upward,
the R/C car goes forward.
Push the control lever downward the R/C car goes backward.
Turn Left/Turn Right
| Push the joystick left and right of the remote control to the left, and the remote control vehicle will turn left. Push the joystick to the right to turn the remote control vehicle to the right.
Note: The effective control distance between the remote control and the vehicle is approximately 40 meters. If the remote control is out of frequency or does not operate during frequency synchronization, it will hibernate after 1 minute. If operation is necessary, restart the remote control and the vehicle’s power switch.
Battery installation
Open the body battery cover and install 2×1.5V “AA” non-rechargeable batteries in the right polarity direction and cover the battery cover.
Function introduction of remote controller of gravity induction Watch
-
ON /OFF
Long press: power switch
Short press: Lock all function, All lights are on at the same time.
Short press again to release, Light 2 and Light 3 are on. -
Function Conversion
Long press: Enter automatic presentation mode (Press any key to exit)
Short press: Enter mode two (Press any key to exit) -
The effective control distance of the gravity induction watch remote controller is about 35m.
a) Light
Gravity sensing watch remote control battery description
2 Gravity Induction remote controls (Operate as shown below)
- Built in 3.7V lithium battery
- 3V CR2032 button battery
1. BUILT-IN BATTERY CHARGING
1. USB Charging Cable
- Connect the Gravity Induction R/C to the USB charging cable
- Plug the other end of the USB charging cable into the USB port for charging
2. INSTALL THE BATTERY
Open the battery cover, Install 3V CR2032 button battery, Close the battery cover.
Handle Remote Control frequency alignment
-
First, turn on the power switch of the automobile body. The light of the automobile body flashes.
Then, turn on the power switch of the remote controller, and start frequency alignment. When the frequency alignment succeeds, the light of the automobile body goes on. -
When the frequency alignment fails, the power light of the remote controller and the light of the automobile body flash continuously. When the connection fails, please repeat the above operations.
-
No operation after frequency alignment. After 1 minute, the remote control car and remote control enter sleep mode, and the frequency alignment connection needs to be reconnected.
Gravity induction watch R/C frequency alignment
- Long press the power switch of the gravity remote controller to start the frequency alignment. When the frequency alignment succeeds, the light 2 and light 3 of the remote controller go on. In case of no operational, the sleep mode starts one minute later
- When the frequency alignment fails, the light 1 and light 4 of the remote controller flash continuously. When the connection fails, please repeat the above operations.
- No operation after frequency alignment. After 1 minute, the remote control car and remote control enter sleep mode, and the frequency alignment connection needs to be reconnected.
Gravity induction watch R/C Operating instructions
MODEL 1
Palm downward, the forward light 2 goes on, the R/C car goes forward;
Palm upward, the backward light 4 goes on, the R/C car goes backward.
Palm towards left, light 1 goes on, the R/C car left crosswise;
Palm towards right, light 3 goes on, the R/C car right crosswise.
Raise the gesture, the R/C car body twigs and arches;
lower the gesture, the R/C car body twists and parallels.
MODEL 2
Press the switch key, palm down, forward light 2 lights up, and the remote control vehicle moves forward; With the palm of your hand facing up, the reverse lamp 4 lights up, and the remote control vehicle moves backward.
Palm towards left, the left turning lights (1, 2, 4) go on, and the R/C car
turns left;
Palm towards right, the right turning lights (2, 3, 4) go on, and the R/C car
turns right.
Raise the gesture, the R/C car body twists and arches;
lower the gesture, the R/C car body twists and parallels.
PRECAUTIONS FOR BATTERY USE
- Before playing please charge the new battery pack.
- The output voltage used by the charging plug should be 5V;
- The higher the actual milliampere of the rechargeable battery, the longer the charging time;
- Rechargeable batteries can only be charged under adult supervision;
- During charging, the light of the USB charging cable head is on red. When the light goes out, it indicates that the lithium battery is fully charged. The charging time is 3-4 hours.
- First plug the battery pack plug in the charger, then plug the charger plugged in the socket.
- Take out and put in the battery according to the mark on the toy battery room;
- Non-rechargeable batteries cannot be charged;
- Use only the same or identical battery as recommended;
- Do not mix-use old and new batteries or different types of batteries;
- Batteries should be placed in the correct polarity;
- Remove the exhausted battery from the toy;
- Power terminals should not be short-circuited;
- The charger must be checked regularly for damage to its wires, plugs, housings and other components. If damage is found, stop using the charger until it is repaired.
General Trouble Shooting
Symptoms | Cause Of Issue | Approach |
---|---|---|
Vehicles Can Not Drive |
- The remote control is not connected or remote control car switch is not turned on.
- The controller or the car does not load the battery proper.
- The recharge bal battery power is low.
|
- Turn on the control car and connect again.
- Insert the battery into the remote control or remote control car correctly.
- Charge the battery pack.
Vehicle Is Out Of Control, Remote Control Distance|
- There is not enough power in the remote control battery or rechargeable battery pack.
- There may be sources of interference near the site.
|
- Replace the battery inside the remote control with a new battery or charge the rechargeable battery pack.
- Change the venue.
Abnormal Protect| When the function of the remote control car is hindered by the external force and can not finish the full function of the function or the circuit battery is short-circuited.| Re-open the power switch remote car power protection.
Instructions
Battery chargers that use this toy must be regularly checked to prevent damage to the wires and other components and, if damaged must be repaired for damage.
Maintenance Matters
- Can not close to the fire, avoid direct sunlight, high temperature and humidity or long-term in the car, to avoid short circuit, fire.
- Do not play when the car and remote control battery removed. And the remote control car remote control I back into the color box packaging, to avoid damage or deformation during transport or storage.
- Remote control car with a damp cloth to gently wipe.
TIPS
When the car moves, please do not touch the wheels of the remote control car, so as to avoid injury.
Do not play on the curb or in dangerous places to prevent accidents.| Do not
play remote control car in the sump.
---|---
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and c an radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help important
announcement
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>