klaxon PSB-0002 Sonos DC Xenon Beacon Instruction Manual
- October 30, 2023
- KLAXON
Table of Contents
klaxon PSB-0002 Sonos DC Xenon Beacon Instruction
Product Information
The Klaxon Signals Sonos DC Xenon Beacon is a high-impact polycarbonate signaling device for visual alerts. It has an IP65 rating, which makes it suitable for outdoor installations. The beacon has a supply voltage range of 10-60V DC and consumes a current of 350mA peak at 24V DC (60 single flashes per minute) or 700mA peak at 12V DC (60 single flashes per minute). The device produces a flash rate of 60 flashes per minute with a power of 5J.
Technical Specifications
- Supply Voltage: 10 – 60V DC
- Current: 350mA peak @ 24V DC (60 single flashes per min.) 700mA peak @ 12V DC (60 single flashes per min.)
- Energy: 5J
- Flash rate: 60 per minute
- Casing: High Impact Polycarbonate IP Rating: IP65
Product Usage Instructions
Installation: The Sonos DC Xenon Beacon can be locked to the base by removing the thin section of plastic on the side of the sounder, as shown in Fig. 1a, or by using the hexagonal locking screw, as shown in Fig. 1b. To change the flash mode of the beacon, use the 2-way dipswitch on the base of the beacon head. Switch 1 is for single flash mode (60 flashes per minute), while switch 2 is for double flash mode (30 flashes per minute).
Wiring: Connect the line, common positive supply, beacon negative supply, and terminal markings (3) IN+ (1) to the appropriate wires.
Note: Products marked with the symbol on the device cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information, visit www.recyclethis.info.
Installation
If required, the mechanism for locking the beacon to the base can be activated by removing the thin section of plastic shown in Fig. 1a with side cutters or a similar tool. To open a locked head, remove the small rubber bung from the hole on the side of the sounder, insert a tool into the hole and depress the clip whilst twisting the head. The O-ring and bung must be re-fitted to maintain the weatherproofing. An alternative locking method is shown in Fig. 1b. Drive the hexagonal locking screw forward by turning a 1.5mm hexagonal key clockwise until the head is locked.
Wiring
Controls
The flash mode of the beacon can be altered using the 2-way dipswitch on the base of the beacon head
Technical Specification
Products marked with this symbol cannot be disposed of as unsorted municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info.
Klaxon Signals is a registered trademark of Texecom Ltd.
St Crispin Way, Haslingden, BB4 4PW, UK
Tel: +44 1706 233879
Email:sales@klaxonsignals.com
Issue 4 (April 2014) INS603-4
Copyright © Texecom Ltd
www.klaxonsignals.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>