DUSTBANE Hurricane Maxi Floor Auto Scrubbers User Guide

: October 30, 2023
: DUSTBANE

Table of Contents

DUSTBANE Hurricane Maxi Floor Auto Scrubbers
Quick Guide
Product Information
Battery Charger On Board
PREPARATION AND OPERATION
DAILY MAINTENANCE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

DUSTBANE Hurricane Maxi Floor Auto Scrubbers

DUSTBANE-Hurricane-Maxi-Floor-Auto-Scrubbers-PRODUCT

Quick Guide

This guide is intended for quick consultation only and does not replace the user and maintenance manual. Before using this machine, read the user maintenance manual contained in the machine’s packaging and follow all the instructions.

Product Information

The Hurricane Maxi is a floor scrubber that is designed to clean hard surfaces such as concrete, tile, and vinyl. It has a solution tank where water and detergent can be added, and a squeegee that collects dirty water into a tank. The Hurricane Maxi also has a brush motor, vacuum motor, and an ECO mode that reduces power consumption by 20%.

Battery Charger On Board

Make sure the squeegee is clean and the blades are not worn.
Position the pad driver underneath the head, in the centre.
Remove the blade.
Put the same blade back, reversing the edge in contact with the floor, or replace with a new one.
Reposition the blade retainer and fix the wing nuts back.
Rest the brush on the floor in front of the machine.
Raise the front of the machine by levering on the handle, then lower it onto the brush, centring it with the brush cover.
Action the drive lever repeatedly until the brush and vacuum motors are deactivated.
Unscrew the wing nuts fixing the blade retainer.
Remove the blade retainer.
Put the same blade back, reversing the edge in contact with the floor, or replace with a new one.
Reposition the blade retainer and fix the wing nuts back.

PREPARATION AND OPERATION

Add water and detergent to solution tank.
Power on
Pull up on lever to adjust the angle of the handle.
Pull squeegee lever to lower.
Press once to turn brush motor, or vacuum motor ON or OFF.
Press and hold brush or Vacuum button for 3 sec. to turn ECO mode ON or OFF
When ECO mode is activated, the Brush and Vacuum light will flash continuously. ECO mode reduces power of motor by 20% to reduce battery consumption
Turn valve manually to adjust water level.
Press once to turn water ON or OFF.
Pull lever to activate scrubber

DAILY MAINTENANCE

Clean the dirty water tank.
Make sure the dirty water tank Make sure detergent outlet float is undamaged and clean filter is clean and free of and moves freely on the pin. debris.
Make sure the pad driver is clean and not worn out.
Replace if necessary. Make sure the squeegee is clean and the blades are not worn.

TO CHARGE BATTERIES
Plug in On Board charger to charge batteries if equipped.

NOTE: Never stop charge until cycle is complete (green light).

REPLACING THE SQUEEGEE BLADES

Unscrew the wing nuts fixing the blade retainer.
Remove the blade retainer.
Remove the blade.
Put the same blade back, reversing the edge in contact with the floor, or replace with a new one.
Reposition the blade retainer and fix the wing nuts back

ATTACHING/REMOVING THE PAD DRIVER

Position the pad driver underneath the head. in the centre(single-brush floor scrubber), position the pad driver underneath the head on both sides (double brush scrubber), switch the machine on.
Press the ON-OFF switch, once after starting the machine releases pad driver attachment. The button is only enabled when all the functions are deactivated (suction motor and pad driver).

Contact