SYNCWIRE SW-MPH238 Magnetic Car Mount User Manual
- October 30, 2023
- SYNCWIRE
Table of Contents
SYNCWIRE SW-MPH238 Magnetic Car Mount
Dashboard Magnetic Car Mount
Square-shaped Magnetic Plate
Round-shaped Magnetic Plate
Square-shaped Static Sticker
Round-shaped Static Sticker
Alcohol Pad
3M Pad
Installation Guide
- Choose targeted area (need to be flat), wipe it with the included alcohol pad, and wait until it is dry completely (about 15 seconds).
- Peel off the protector of car mount base, apply the car mount, and press it to the target spot for 10 seconds to strengthen the attachment.
- Put the magnetic plate on your phone (two methods are provided for your choice).
- Choose the magnetic plate you like (two shapes of plates are offered) and find corresponding static sticker. Remove the protector of the static sticker and put it on the back of your phone.
- Remove the protector of the magnetic plate and place it on the static sticker you just applied.
Congratulations! You have installed the car mount perfectly. If you want to remove the magnetic plate, please pull on the static sticker and it won’t leave a mark on your phone.
If you use non-transparent phone cases:
Choose the magnetic plate you like (two shapes of plates are offered) and stick it on the inner side of your phone case. Find the corresponding static sticker, remove its protector, and put it on the magnetic plate you just applied (this can prevent phone scratches caused by magnetic plate).
Congratulations! You have installed the car mount perfectly!
Try your new car mount and adjust it to your best viewpoint. One car mount can only be installed for once and if you need to change the place, we offered a spare 3M pad to replace the one used on the car mount base.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>