M-Style Vehicle-Mounted Power Supply System User Manual
- October 30, 2023
- M-Style
Table of Contents
M-Style Vehicle-Mounted Power Supply System
Operation Manual of Vehicle-Mounted Power Supply System
Item : Parameter
- Input 12-24V
- Output 5V /9V /12V•2.4A
- Cable Length 2.5 meters
- Qualcomm qc2.0 / qc3.0 MTK PE+ 1.1 / PE +2.0SFCP,
- Qiuck charging protocol support DCP (apple, Samsung and bcl .2)Huawei fast charging protocol FCP supports Huawei super fast charging protocol (SCP)
Please pay attention:
ACC means that after the white ACC line is connected to the ACC line of the
motorcycle, the motorcycle can be opened The key can be power red on (long-
term) and the key can be turned off (long-term). so as to realize the power
supply through the motorcycle key Key on and off to control the working state
of USB charging cable
Note: the installation of this line involves relevant professional knowledge, which needs to be installed by professional technicians. The damage caused by improp er installation will lose the relevant free warranty service.
Two kinds of line installation methods are available:
- Pull out the key to power off: connect the white ACC line of the charging line with the ACC line of the motorcycle. The switch of the charging line can be controlled by the key switch of the car. Connect the main line of the charging line red to the positive pole of the battery and black to the negative pole of the battery lnstallation involves relevant professional kn owl edge. It is recommended to go to the motorcycle repair shop for professional maintenance and technical personnel
- Continuous power on: connect the main red and white ACC wires of the charging cable to the positive pole of the battery, connect the black wire to the negative pole of the motorcycle battery, and the USB charging cable will be continuously powered onu Installation involves relevant pro fessional knowledge. It is recommended to go to the motorcycle repair shop for professional maintenance and technical personnel
Multiple installation options
- Option 1: USB del ivery outl et is instal lation on the comnercting rod of mob ile phone holder (as shown in figure 2) it can be removed togerther with the hol der when not in use
- Option 2: USB buckle and flexible joint chain coordinated with 3M double-sided adhesive (see Figure 3) are pasted in the position needed to install;
- Option 3: USB buckle and flexible joint chain coordinated with 3M double-sided adhesive (seeFigure 3) are installed on suitable position of the backseat for the use of passengers, and can be installed in the glove compartment of the backseat for charging the electronic devices;
- Option 4: USB buckle and flexible joint chain coordinated with 3M double-sided adhesive (see Figure 3) and prick bar are used on the tube (see Figure 4 ).
Corresponding accessories based on Fig. 2
Complete assembly in sequence
This scheme is suitable for fixing the company’s series of support
Select corresponding accessories based on Fig. 3 Complete assembly in sequence
This scheme is suitable for sticking on the car.
Warnings
- Make sure that the output voltage of the battery is between 12Vand 24V before the main line is connected to the battery.
- Since the battery pack of electric vehicles is a combination of multiple batteries, please confirm that the battery voltage is 12-24V before using this Product. If it exceeds the output range of 12-24V, please do not connect to this Product, or ask professional and technical personnel to confirm before the connection.
- When not charging , Be sure to the USB delivery outlet cover rightly with a waterproof cap ,Avoid dust or rain damage the power supply system
- If there is any di rt on the USB output bus, please it in time. When not in use, please cover the waterproof cap of the USB bus To prevent rain and dust franc entering and causing damage, do not use high-pressure water gun to clean the USB bus, or there may be a short circuit.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>