Anmossi LST-10M 10m Smart Bluetooth RGB LED Strip User Manual
- October 30, 2023
- Anmossi
Table of Contents
Anmossi LST-10M 10m Smart Bluetooth RGB LED Strip
Product Information
This product requires a power input of +24V. It comes with a one-year warranty and can be replaced for free if any quality problems occur. For after-sales support, please reach out to sy-andy@hotmail.com.
Product Usage Instructions
- Make sure the power supply is disconnected before installing the product.
- Connect the +24V power supply to the designated input on the product.
- Once the power supply is connected, the product is ready for use.
- If you encounter any problems while using the product, please contact after-sales support at sy-andy@hotmail.com for assistance.
Installing Steps
Product Parameters
- View angle: 120°
- LED Strip Light: 24V
- Power Supply: AC100-240V
- Color: RGB
- Waterproof Rating: IP20
Accessories
- LED Strip Light
- Controller
- User Manual
- Power Supply
- Receiver Box
- Brackets Holder
After-Sales Email: sy-andy@hotmail.com. If you encounter any problems, please contact us to solve for you. (This product is free to replace within 1 year if any quality problems occur)
Using Tips
- Please stick the strip light on the clean and flat surface, with no dust, no watermarks. Please test the product to see if it works before pasting.
- Please note that the arrow position of the controller should be aligned with the strip light mark “+24V”, otherwise the light will not light up.
- Make sure that the IR receiver is not blocked. Please aim at the receiver. Otherwise, the controller will be insensitive or out of control.
- Please fix the wiring on the object with wire clip to avoid pulling off the strip interface.
- This product is designed for indoor use, not suitable for outdoor use.
- Do not roll up the strip during using. Please spread out the strip light before connection.
How to control with APP
- IOS and Android system mobile phone can download the app by scanning the QR code.Open a browser or other apps with the “Scan QR Code” function and scan the following QR code to download the app. APP name: HappyLighting
- Install the APP,click the “HappyLighting” icon to enter the application page.
- After entering the application interface, if Bluetooth is not enabled,the application will enable the Bluetooth function of this device, please click “Allow”.
- Please note that the device can only connect to one phone at a time. Make sure no other phones are connected to the device before connecting.
- Click ton left icon to display the Bluetooth list
- Switch color and brightness interface
- Lighting mode interface
- Music interface
- Microphone mode interface
- Timer interface
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>