InnovaSpa VS300 System Controller Pack Balboa User Manual
- October 30, 2023
- InnovaSpa
Table of Contents
InnovaSpa VS300 System Controller Pack Balboa User Manual
BALBOA VS300 EQUIPMENT
-
The electronic box is located under the keyboard, behind the side panel;
-
Change the DIP Switch; a) Turn #10 to the OFF position (down);
MAKE SURE THE SWITCHES ARE
IN THE FOLLOWING POSITIONS
BALBOA VS300 EQUIPMENT
-
Connect the necessary cables to the 240 V. See diagram in Annex 1 and information on wire in Annex 2;
-
Close the electric box, seal the Thermofoil and close the side panel;
-
Open the hot tub. On the keyboard, start up numbers should be 100, 59, 41, 24. If not, the spa is not on 240 V.
DON’T FORGET…
Remove the white cable that joins J11 to J32
- Otherwise, there is a risk of burning out the fuse or damaging the electronic board. On the DIP switch, set position 10 down
- Otherwise, the hot tub will continue to heat as if it were on 120V. Do not connect anything in the J1 zone when on the 240V
- Otherwise, risk of overheating of the pump. Install 3 wire stands
- f the electrician uses 2 wire stands, the spa will continue to operate on 120V.
BALBOA ELECTRICAL BOX DIAGRAM
ANNEX 1
INFORMATION ON WIRE
If you plan to operate your spa using a 220V electrical supply, you will be
required to install a 220V 40A (minimum) GFCI breaker.
You have to connect your spa to this GFCI breaker and your home electrical
panel.
Which wire to use?
- If the spa is more than 50’ from the wall outlet: a grounded 6 AWG/3 wire
- If the spa is located within 50’ from the wall outlet: a grounded 8 AWG/3 wire
Don’t forget, we recommend using a certified electrician to install your GFCI breaker and to connect your spa to your house electrical panel. If your spa only runs on a 220V electrical circuit, no conversion is needed for the spa pack.
If your spa is convertible from 110V to 220V, you will find instructions to convert the spa pack on the inside of the spa pack cover.
For any questions, please contact our service department:
1 866 995-8646, ext 226 or 227
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>