RAK11720 AT Command User Manual
- October 30, 2023
- RAK
Table of Contents
RAK11720 AT Command
Product Information
The RAK11720 is a device that comes with a default firmware based on RUI3 (RAKwireless Unified Interface V3). It provides access to AT commands via UART0 by default. The device comes with a RUI3 AT Commands Documentation, which contains a complete list of commands.
Product Usage Instructions
To use the RAK11720 device, follow the steps below:
- Connect the device to a power source and turn it on.
- Connect the device to a computer or another device using UART0.
- Access the AT command via UART0 by default.
- Refer to the RUI3 AT Commands Documentation for a complete list of available commands.
- Use the appropriate command to perform the desired action.
Note:
For detailed information on how to use each command, refer to the RUI3 AT
Command Manual.
Overview
RAK11720 is based on the Ambiq Apollo3 Blue AMA3B1KK-KBR-B0 SoC MCU and Semtech LoRa transceiver SX1262. It is designed to simplify LoRaWAN and LoRa point-to-point (P2P) communication. It also features BLE functionality of the Apollo3 Blue chip. To integrate LoRa technology into your projects, the RAK11720 is implemented with an easy-to-use Serial Port communication interface where you can send AT commands. Through these AT commands, you can set the parameters needed for LoRa P2P and LoRaWAN communication.
Command-List
- The RAK11720 default firmware is based on RUI3 (RAKwireless Unified Interface V3). You can access the AT command via UART0 by default.
- The complete list of commands can be found in RUI3 AT Commands Documentation.
References
- RAKwireless Unified Interface V3 (RUI3) | RAKwireless Documentation Center
- AT Command Manual | RAKwireless Documentation Center
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>