Blue Flame Town Gas Chinese Bloweless Wok Range User Manual

Table of Contents

Wipe the stainless steel components with a soft, damp cloth and mild detergent.
Wash the Pan Support in warm water and detergent.
Do not clean the top of the flame failure safety sensor and the pilot flame jet with a hard brush, as it may damage the sensor and the pilot flame jet.

If you smell gas or suspect there is a gas leak, YOU SHOULD:

Open all windows and doors to allow the gas to disperse.
Check your appliances to see whether the gas control has accidentally been left on without ignition.
Extinguish all naked flames and turn off gas meter control valve to cut off gas supply.
If all appliances have been shut off and you still smell gas, immediately call our 24-hour Emergency Hotline 2880 6999. Make this call from outside your premises.

Remember

Do not operate any electrical switches, such as switching on or off lighting fixtures.
Do not use telephones or mobile phones inside your premises.
Do not use matches or lighters.
Do not use a naked flame to try to trace a suspected gas leak.
Do not press the doorbell of an adjacent flat.
Do not turn on any gas appliances again until a situation under control by authorized personnel.

Note

Check that all gas cocks are closed before the main supply gas valve is opened.
After work, before closing down the kitchen, check that all gas cocks are closed and then shut off the main supply gas valve.
When using the gas appliance, please switch on the central exhaust system to ensure adequate air ventilation.

In order to ensure proper use and to maintain your gas appliance in the best condition, please read the instructions below carefully before use.

Blue-Flame-Town-Gas-Chinese-Bloweless-Wok-
Range-FIG-1

Installation of Town gas appliances or work on any pipe works and gas fittings must only be done by Registered Gas installers. This is stipulated by law and is an important safety precaution. So do not try to do it yourself or let unauthorised person do it for you.
This gas appliance is to be used for cooking purpose only. Do not dry towels, clothes, etc. over it.
Install the gas appliance in a well ventilated area and keep it away from any combustible or inflammable objects such as paper or oil.
Place the gas appliance on a stable and level surface, and below an exhaust hood.

Blue-Flame-Town-Gas-Chinese-Bloweless-Wok-Range-
FIG-2

Turn On

Before igniting, please make sure that all gas control valves are at the “OFF” position.
Turn on the Ignition Rod Valve, ignite the Ignition Rod.
Turn on the Pilot Control Valve, ignite the Pilot using the Ignition Rod and press the Safety Control Valve simultaneously for around half a minute.
Release the Safety Control Valve and turn off the Ignition Rod Valve. If the pilot flame goes out, repeat the above ignition procedures again.
Turn Flame Control Valve to adjust flame to desired setting
If the flame is extinguished while using, the Flame Failure Safety Device will shut the gas off after a short delay. If you notice the flame is extinguished, please turn the Flame Control Valve to “OFF” position

Turn Off

Turn the Flame Control Knob backwards to the “OFF” position to extinguish the burner.
If the gas appliance will not be used for a prolonged period, please turn off the Pilot.

Fault
For any problems in operating the appliance, please call Towngas for service at 2880 6988