Blue Flame 3-Burner Unit Town Gas Griddle Range User Manual

Blue Flame 3-Burner Unit Town Gas Griddle Range

Daily Maintenance Procedure

1. Wipe the stainless steel components with a soft, damp cloth and mild detergent.
2. Drain out oil from Oil Collection Drawer regularly.

Handling Gas Leaks

If you smell gas or suspect there is a gas leak, YOU SHOULD:

1. Open all windows and doors to allow the gas to disperse.
2. Check your appliances to see whether the gas control has accidentally been left on without ignition.
3. Extinguish all naked flames and turn off gas meter control valve to cut off gas supply.
4. If all appliances have been shut off and you still smell gas, immediately call our 24-hour Emergency Hotline 2880 6999. Make this call from outside your premises.

Remember

1. Do not operate any electrical switches, such as switching on or off lighting fixtures.
2. Do not use telephones or mobile phones inside your premises.
3. Do not use matches or lighters.
4. Do not use a naked flame to try to trace a suspected gas leak.
5. Do not press the doorbell of an adjacent flat.
6. Do not turn on any gas appliances again until a situation under control by authorized personnel.

Note

1. Check that all gas cocks are closed before the main supply gas valve is opened.
2. After work, before closing down thekitchen, check that all gas cocks are closed and then shut off the main supply gas valve.
3. When using the gas appliance, please switch on the central exhaust system to ensure adequate air ventilation.

In order to ensure proper use and to maintain your gas appliance in the best condition, please read the instructions below carefully before use.

Components and Parts Names

Installation

1. Installation of Town gas appliances or work on any pipe works and gas fittings must only be done by Registered Gas installers. This is stipulated by law and is an important safety precaution. So do not try to do it yourself or let unauthorised person do it for you.
2. This gas appliance is to be used for cooking purpose only. Do not dry towels, clothes, etc. over it.
3. Install the gas appliance in a well ventilated area and keep it away from any combustible or inflammable objects such as paper or oil.
4. Place the gas appliance on a stable and level surface, and below an exhaust hood.

Specifications

Dimensions may vary according to customer’s requirement

Operation Instruction

Turn On

1. Push the Ignition/Flame Control Valve fully and turn it anti-clockwise to the maximum position until you hear a “click” sound, then the burner will be lit in maximum capacity.
2. Hold this position for a few seconds until the Flame Failure Safety Device operates. The flame should remain lit. If the flame goes out when you release your hand, repeat the above ignition procedure again.
3. Turn Ignition/Flame Control Valve to adjust flame to desired setting.
4. If the flame extinguished while using, the Flame Failure Safety Device will shut the gas off after a short delay. If you notice the flame was extinguished, please turn the valve to “OFF” position.

Turn Off

1. Turn the Ignition Control Knob backwards to the “OFF” position to extinguish the burner.

Fault
For any problems in operating the appliance, please call Towngas for service at 2880 6988.

Model No.: 2, 3-burner unit

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>