Blue Flame 6-Burner Town Gas Boiling Table User Manual

Table of Contents

Wipe the stainless steel components with a soft, damp cloth and mild detergent.
Wash the Pan Support in warm water and detergent.
Do not clean the top of the flame failure safety sensor and the pilot flame jet with a hard brush, as it may damage the sensor and the pilot flame jet.

If you smell gas or suspect there is a gas leak, YOU SHOULD:

Open all windows and doors to allow the gas to disperse.
Check your appliances to see whether the gas control has accidentally been left on without ignition.
Extinguish all naked flames and turn off gas meter control valve to cut off gas supply.
If all appliances have been shut off and you still smell gas, immediately call our 24-hour Emergency Hotline 2880 6999. Make this call from outside your premises.

Remember

Do not operate any electrical switches, such as switching on or off lighting fixtures.
Do not use telephones or mobile phones inside your premises.
Do not use matches or lighters.
Do not use a naked flame to try to trace a suspected gas leak.
Do not press the doorbell of an adjacent flat.
Do not turn on any gas appliances again until a situation under control by authorized personnel.

Note

check that all gas cocks are closed supply gas opened.
After work, before closing down the check that all gas cocks are closod and then shut off the main suoply
When using the gas appliance, please switch on the central exhaust system to ensure adequate air ventilation

In order to ensure proper use and to maintain your gas appliance in the best condition, please read the instructions below carefully before use.

$Blue-Flame-6-Burner-Town-Gas-Boiling-Table- fig- $1$$

$Blue-Flame-6-Burner-Town-Gas-Boiling-Table-fig- $2$$

Installation of Town gas appliances or work on any pipe works and gas fittings must only be done by Registered Gas installers. This is stipulated by law and is an important safety precaution. So do not try to do it yourself or let unauthorised person do it for you.
This gas appliance is to be used for cooking purpose only. Do not dry towels, clothes, etc. over it.
Install the gas appliance in a well ventilated area and keep it away from any combustible or inflammable objects such as paper or oil.
Place the gas appliance on a stable and level surface, and below an exhaust hood.

Height of back-splash panel is 150mm

Turn Or

Push the Ignition / Flame Control Valve fully and turn it anti-clockwise to the “Pilot” position until you hear a “click” sound, then the pilot burner will be lit. Hold it in this position for a few seconds until the Safety Device operates. The pilot flame should remain it.
If the pilot flame goes out when you release your hand, repeat the above ignition procedure again. Turn Control Valve, adjust flame to desired setting. If the flame is extinguished while using, the flame failure device will shut the gas off after a short delay. If you notice the flame was extinguished, please turn the valve to “OFF” position.

Turn Off