CREALITY Ender-3 CR Touch Auto Bed Leveling Sensor Instruction Manual
- June 10, 2024
- Creality
Table of Contents
CREALITY Ender-3 CR Touch Auto Bed Leveling Sensor Instruction Manual
Packing List
Circuit Principle
CREALITY Ender-3 CR Touch Auto Bed Leveling Sensor Instruction Manual – Circuit Principle
Update Firmware
-
Right-click the mouse to format SD card. (To make sure tale firmware can be flashed successfully, please format the SD card before flashing the firmware)
-
Firmware download (before downloading firmware, please confirm your model, motherboard version, and hardware configuration-whether it comes with filament sensor or not}. Note: 1he SD card can only holds one firmware file.
File download website: https://www.creality.com/download -
Copy the firmware to the SD card. Note: the SD card can only hold one firmware file.
Wait for the firmware to complete upgrade (about 10 seconds).
Install CR Touch
Circuit Wiring
To connect CR Touch and 32-bit motherboard by 5 pin cable .
Note: Unplug the cable tram z end stop/limit switch.
Steps
-
To get the z offset Value
Operation: Prepare→ Auto Home→ Move Axis→ Move z→ Please stop to move Z axis when 1he distance between the nozzle end the printer bed Is about 0.1 mm (the height of a sheet of A4 paper). This value shows Z offset val1J0. -
Input the z-axis compensation value (Z offset value)
Record the Z offset value, then follow below save settings: Prepares ➔ Auto home ➔ Control ➔ Bad Leveling- Probe Z offset ➔ Input the Z offset value – Store Settings -
Select Bed Leveling, then choose Level Bed.
Operation: Control Bed Leveling Level Bed. (Diff8ranl 3D printers may have different numbers of touching points for automatic leveling. The picture here shows that Ender-3 has 9 points far leveling.) -
Model Printing
After the automatic leveling~ user can do a trial print to Verify the leveling. Operation: Print from SD Card-Model Test (Name and file of the testing model shall be prepared by user.)
Test passed: leveling is completed and you can print now;
Test felled, If model printing falls, please fine-tune Probe Z Offset again
and save settings until the printing effect Is good.
Note: Every machine has Its ov.T1 operation interface.
Software Settings
Appendix 1:
MADE IN CHINA
SHENZHEN CREAL I TY 30 TECHNOLOGY C0.1 LTD.
Add: 18F, JinXiuHongDu Building, Meilong Blve,.
Longhua Dist., Shenzhen, China 518131
Official Website: www.creality.com Tel: +46
755-8523 4565
E-mail: info@creality.com
cs@creality.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>