JIECANG JCHR35W2A 6-Channel LED Remote Controller User Manual
- June 6, 2024
- JIECANG
Table of Contents
- Product Info
- Buttons
- Caution!
- [Operation Instruction]](#Operation+Instruction%5D)
- Caution!
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
JIANG JCHR35W2A
6-Channel LED Remote Controller
User Manual
Product Info
|
---|---
Hand-held 6-channel LED remote controller| Wall-mounted 6-channel LED
remote controller
Buttons
a. Front
|
---|---
Hand-held 6-channel LED remote controller| Wall-mounted 6-channel LED
remote controller
b.Back
|
---|---
Hand-held 6-channel LED remote controller| Wall-mounted 6-channel LED
remote controller
103 Models & Parameters (more info please refer to the nameplate)
Electrical Specification | Standard |
---|---|
Battery Type | Hand-held: CR24503V1 |
Working Temperature | -lOt-50°C |
Radio Frequency | 433.92M ± 100KHz |
Transmit Distance | >=30m indoor |
Caution!
- The transmitter should not be exposed to moisture or impact, so as not to affect its life
- During use, when the remote control distance is significantly shorter or less sensitive, please check whether the battery needs to be replaced.
- When the battery voltage is too low, the orange LED will flicker during operation. 4. Please properly dispose of used batteries according to the local garbage classification and recycling policy
Operation Instruction]
a.Prohibit dual-key operation
Repeat the above, dual-key operation activated
Note: When the dual-key operation is prohibited, these programming
setting functions are not allowed
b.Number of Channels Setting
c.For other operations, please refer to the motor operation instruction
Caution!
This device complies with Part 15 of the FCC. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada’s license-exempt RSS. Operation is
subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Headquarter: Xinchang
ADD No. 2 Laisheng Road, Provincial High-tech Industrial Park,
Xinchang County, Zhejiang Province
EMAIL: jc35@jiecang.com
TEL : +86-575-86297980
FAX : +86-575-86297960
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>