LEITNER HEADSETS B01JT9UAHU Electronic Hookswitch Owner’s Manual

LEITNER HEADSETS B01JT9UAHU Electronic Hookswitch

The Electronic Hookswitch (EHS) is a device that allows you to answer and end calls remotely, without the need for a mechanical lifter. Follow these instructions to set up your EHS:

1. Unplug the power cord from the headset base. Set the RHL/DHSG switch on the bottom of the base to RHL.
2. Set the compatibility switch to 1 TELEPHONE CONNECTOR jack (the smaller jack, second from the right).
3. Connect the Y-side of the EHS to the AUX jack (the largest jack in the center of the base) and the telephone jack.
4. Connect the other side of the EHS cable into the HEADSET JACK of the Avaya or Shoretel Phone.
5. Next plug the Ring Sensor into the small jack on the EHS Cable Box.
6. Remove the white tape from the Ring Sensor and firmly stick the sensor over the speaker of the phone.
7. Lastly, plug your power cable back in to the back of the charging base.

FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

If you need more help, call 1-800-432-3738 Mon-Fri 9am-7pm Eastern Time for free support!

INSTALLATION INSTRUCTION

1. Unplug the power cord from the headset base. Set the RHL/DHSG switch on the bottom of the base to “RHL.”
2. Set the compatibility switch to “1”
3. Connect the Y-side of the Electronic Hookswitch (EHS) to the headset base in both the AUX jack (which is the largest jack in the center of the base) and the TELEPHONE CONNECTOR jack (the smaller jack, second from the right).
4. Connect the other side of the EHS cable into the HEADSET JACK of the Avaya or Shoretel Phone.
5. Next plug the Ring Sensor into the small jack on the EHS Cable Box.
6. Remove the white tape from the Ring Sensor and firmly stick the sensor over the speaker of the phone.
7. Lastly, plug your power cable back into the back of the charging base.

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Want more help?
Call 1-800-432-3738 Mon-Fri 9am-7pm Eastern Time for free support!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>