LEITNER HEADSETS B01JT9UAHU Electronic Hookswitch User Guide

LEITNER HEADSETS B01JT9UAHU Electronic Hookswitch

This quick start guide provides step-by-step instructions for setting up the Electronic Hookswitch with your Cisco phone and headset. Please follow these instructions carefully.

Product Information

• The RHL/DHSG switch on the bottom of the base must be set to RHL.
• The compatibility switch must be set to 4.
• The Electronic Hookswitch (EHS) has a smaller end and a larger end.
• The AUX jack on the back of the Cisco phone is used to connect the EHS.
• The cable included with your headset is used to connect the headset to the Cisco phone.
• The power cable should be plugged into the back of the charging base.

Product Usage Instructions

1. Unplug the power cord from the headset base.
2. Set the RHL/DHSG switch on the bottom of the base to RHL.
3. Connect the smaller end of the EHS to the AUX jack on the back of the Cisco phone.
4. Set the compatibility switch to 4.
5. Take the cable that came with your headset and plug one end into the Telephone Connector jack on the back of the headset base (this is the jack second from the right). Connect the other side of this cable to the HEADSET JACK of the Cisco telephone.
6. Connect the larger end of the Electronic Hookswitch (EHS) to the AUX jack on the back of the base. This is the largest jack in the center of the base.
7. Plug your power cable back in to the back of the charging base.
8. If you experience any issues, please call 1-800-432-3738 Mon-Fri 9am-7pm Eastern Time for free support.

FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

INSTALLATION INSTRUCTION

1. Unplug the power cord from the headset base. Set the RHL/DHSG switch on the bottom of the base to “RHL.”
2. Set the compatibility switch to “4”
3. Connect the larger end of the Electronic Hookswitch (EHS) to the AUX jack on the back of the base. This is the largest jack in the center of the base.
4. Connect the smaller end of the EHS to the AUX jack on the back of the Cisco phone.
5. Take the cable that came with your headset and plug one end into the Telephone Connector jack on the back of the headset base (this is the jack second from the right). Connect the other side of this cable to the HEADSET JACK of the Cisco telephone.
6. Lastly, plug your power cable back in to the back of the charging base.

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Want more help?

Call 1-800-432-3738 Mon-Fri 9am-7pm Eastern Time for free support!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>