HEAD TWS Earbuds with Charging Case User Manual
- June 10, 2024
- HEAD
Table of Contents
HEAD TWS Earbuds with Charging Case
- Take out the left and right earphones from the charging compartment, the earphones will automatically turn on after a couple seconds.
- The main earphone (B) will enter the pairing mode (flashing red and blue light).
- Both earbuds will sync with each other automatically.
- Enter Bluetooth mode on your mobile device, search for “HEAD TWS Earbuds”, and select. There will be a prompt stating, “Connected”. This means both earphones are connected and synced up to your mobile device.
SAFETY INSTRUCTIONS
Please read these instructions carefully before operating this device.
POWER SOURCE
- Only use the power supply that came with the product. Using an unauthorized power supply will invalidate your guarantee and may irrecoverably damage the product.
MOISTURE AND WATER
- Do not leave it in low temperatures as moisture can form inside the product, which may damage the circuit board.
- Keep away from heat sources and flames Do not leave it in high temperatures as electronic devices and plastic parts may warp in heat.
CAUTION
To avoid possible hearing damage, do not listen to music at high volume levels
for long period of time. Always keep the volume within reasonable limits.
GENERAL SAFETY INFORMATION
- Keep the product and all its parts out of reach of small children.
- This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
SPECIFICATIONS
- Bluetooth 5.0
- Ultra-low Charging Case: 9 hours of additional playback/talk power consumption
- Earphone charge time: 1 hour connection
- Distance: 10m — 15m
- Charging case charge time: 1 hour
- Playback time: 3 hours
- Earphone battery capacity: 25mAh
- Talk time: 3 hours
- Charging case battery capacity: 300mAh
- Standby time: 300 hours
BLUETOOTH FUNCTIONALITY
- POWER ON: Take out the charging case or Press and hold the touch button for 5 seconds when turned off.
- POWER OFF: Put it in the charging case , or Press and hold the touch button for 5 seconds when the power on is“ ON”.
- Bluetooth pairing (pairing with mobile phone): Take out the charging case for the left and right earphones, the earphones will automatically turn on, connect left and right, and connect back to the last connected Bluetooth device, and automatically enter the state of pairing with the mobile phone without returning. Long press the touch button for about 5 seconds to manually enter the pairing state when turned off.
- Connect with your mobile phone: The headset enters the pairing state, the mobile phone searches for the Bluetooth pairing name “HEAD TWS Earbuds”, and clicks Connect
- Play/Pause: While music is playing, click the touch key to pause and click play again.
- Next song/volume decrease & Previous song/volume plus: Play music status, double-click L for the next song/long press 2 seconds volume down. Play music status, double-click R for the previous song/long press 2 seconds volume plus.
- Last number redial: Triple tap left and right ears to call back last number.
- Low power: A low battery prompt voice every 2 minutes
- Hang up the call: Click the touch key during the call.
- Reject incoming call: Press and hold for 2 seconds to automatically reject incoming call.
- Hang up the current call and answer the second call: when there is another call, click the touch button to end the current call and answer the second call.
- Reject the second call: when there is another call or the phone is on hold, press and hold the touch button for 1.5S to reject the second call.
- Answer the second call and hold the current call: when there is another call, double-click to hold the current call and answer the second call
- Switch between two phones during a three-way call: When a three-way call is in progress, double-click the touch key to switch between the two calls.
- Voice Assistant: Four blows to the left and right ears wake up the voice assistant.
CHARGING CASE
There are two functions of the charging case: charging and storing the earphones.
- Charging: When the earphones batteries are low, place them into the charging case to begin charging. The red light on the main button of each earphone will be solid red. When the earphones are fully charged, the red lights on the earphones will shut off.
- Storage: When the earphones are not in use, place them inside the charging case. They will automatically disconnect from your device and begin to charge. When taking them out of the case, they will automatically reconnect to your device.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note: Any changes or modifications not expressly approved by the party
responsible for compliance. such modifications could void the user’s authority
to operate the equipment. The device has been evaluated to meet general RF
exposure requirement.
The device can be used in portable exposure condition without restriction.
- HEAD is a registered trademark of
- HEAD Technology GmbH and
- HEAD Sport GmbH and is used under license by CJ GLOBAL Inc.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by CJ Global is under license. Other trademarks and trade names are those of their respective owners.
CJ Global Inc.
All rights reserved. 2010 Maple Ave Fair Lawn NJ 07410.
IC STATEMENT
This device complies with Industry Canada’s license-exempt RSSs. Operation is
subject to the following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.The device has been evaluated to meet general RF exposure requirement. This equipment should be installed and operated with minimum distance 0mm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>