LEDLENSER HF8R Series Headlamp Instruction Manual
- June 10, 2024
- LEDLenser
Table of Contents
HF8R Series Headlamp
Product Information
The product is called HF8R and comes in two variants: HF8R Core and HF8R Work.
It has two modes – White Mode and Red Mode. The default setting is White Mode.
The product can be turned on with a single click and turned off by holding the
button for 2 seconds in
White Mode. In Red Mode, the product can be turned on with a single click and
turned off by clicking once followed by a 5-second hold.
Usage Instructions
Turning On/Off
- In White Mode, turn the product on with a single click and turn it off by holding the button for 2 seconds.
- In Red Mode, turn the product on with a single click and turn it off by clicking once followed by a 5-second hold.
Changing Modes
To switch between White Mode and Red Mode:
- Turn the product on in White Mode.
- Click once to enter Red Mode.
- To switch back to White Mode, click once again.
Default Setting
The default setting is White Mode. To reset the product to its default setting:
- Turn the product off.
- Click once to turn it on in White Mode.
HF8R Core/HF8R Work
HF8R
Signature
Adaptive Light Beam 
Direct to Red Mode (HF8R Core/HF8R Work
Direct to RGB Mode (HF6R Signature) 
Reset to default setting
APP Mode 
HF8R Core
HF8R Work 
HF8R Signature
Magnetic Charge System
Transportation Lock
Boost
Boost Overheat Warning
Battery Indicator
Connecting System Adapter
Comfort Pad
Low Battery Warning
Wall Holder (HF8R Work)
Digital Advanced Focus System
Helmet Adapter(HF8R Work) 
Helmet Connecting System (HF8R Work)
Universal Mounting Bracket (HF8R Signature)
Overheadhand
Ledlenser GmbH & Co. KG
Kronenstrasse 5-7 • 42699 Solingen • Germany
Phone +49 212/5948-0 Fax +49 212/5948-200
info@ledlenser.com
FCC Information to User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Compliance Information:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment
IMPORTANT NOTE:
FCC RF Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. The device has been evaluated to meet general RF
exposure requirement. The devicecan be used in portable exposure condition
without restriction. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>