LEDLENSER H19R Signature Bluetooth Remote Control User Manual
- June 5, 2024
- LEDLenser
Table of Contents
LEDLENSER H19R Signature Bluetooth Remote Control
Remote Control function (H19R Signature)
- Download the LEDLENSER APP in the mobile phone application market, add a Bluetooth device to the APP, and long-press the middle button of the remote control to connect to Bluetooth
Remote Control
- Step 1: Pry open the battery compartment
- Step 2: Remove the battery compartment
- Step 3: Remove the battery and install a new CR2032 battery Part 4: Plug the charging compartment back
- Press the middle button of the remote control, the indicator light will be on, When the amount of points is sufficient, the indicator light is green. When the amount is insufficient, the indicator light is red, reminding the need to replace the battery
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirements.
- The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>