MEDI PRODUCTS Battery Powered Generator Standalone Battery Backup System User Guide
- June 10, 2024
- MEDI PRODUCTS
Table of Contents
Standalone Unit
8-Step Easy Start Guide
Battery Powered Generator Standalone Battery Backup System
Thank You!
For purchasing a Mediproducts standalone battery backup unit. We are certain
you can now be at ease knowing that your most important equipment has the
backup protection it needs. This quick start guide will help get your new
standalone unit ready as soon as possible.
-
Unpack Shipment
Remove each item from the pallet. Each item will weigh LESS than 80 lbs. -
Remove Battery Box Covers
Remove the (2) 1/4″ hex screws from each battery box cover and remove each cover from the system. -
Install Feet
Screw each foot onto the bottom of the system. -
System Startup
Stand the system up on its feet, leaning the system against the wall. Then mount the system to the wall using the wall anchors supplied
Note: Refer to full install guide for further detailed instructions **** -
Install Batteries
Batteries should slide in, with the terminals facing you and the RED terminal at the right side -
Install Cables
Fasten the battery cables to the batteries.
Note: Check the install instructions for 12, 24 and 48 volt battery cable configurations. **** -
Reinstall Covers
Reinstall the battery box covers using the same 1/4″ screws that were removed earlier **** -
System Startup
Be sure the POWER LIGHT, INVERTER LIGHT, and CHARGER LIGHT are ALL on
Refer to the procedures listed in the user operating and testing guide for commissioning, using and testing the system.
Complete!
Your MediProducts standalone battery backup unit is fully installed and ready to protect your most valuable assets. If you’re having any trouble refer to the full-length nstallation guide or call us toll-free at 1-800-765-3237 Once again, we thank you for choosing MediProducts.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>