JIECANG JCHR35W1C/2C 16 Channel LCD Remote Controller User Manual
- June 10, 2024
- JIECANG
Table of Contents
JIECANG JCHR35W1C/2C 16 Channel LCD Remote Controller
Product Information
The JCHR35W1C/2C is a 16-channel LCD remote controller available in two models: wall-mounted and hand-held. The remote controller is designed to control various devices such as lights, shades, and other home automation systems.
Models & Parameters
The wall-mounted and hand-held models have the same parameters, which can be found on the nameplate of the device.
Buttons
The remote controller has several buttons that can be used to control the channels and settings of the connected devices.
Caution!
Before using the remote controller, make sure to read the instructions carefully to avoid any damage or malfunction of the connected devices.
Instructions
To control the channels, use the short press function on the remote controller. Pressing the button once will turn on the channel and pressing it again will turn it off. For the group control of all channels, use Channel 0. To add a channel to the group, short-press the button. The channel number will be steady-lit. To remove a channel from the group, short-press the button again. The channel number will start flashing. To set limits for shades, press and hold the button until the shades start moving. Release the button when the shades reach the desired position. Wait for 3 seconds until the shades stop moving.
Product Info
Buttons
FRONT
BACK
Models & Parameters
(For more info please refer to the nameplate)
Caution
- The transmitter should not be exposed to moisture or impact, so as not to affect its life
- During use, when the remote control distance is significantly shorter or less sensitive, please check whether the battery needs to be replaced.
- When the battery voltage is too low, the LCD screen will show a low voltage prompt, prompting to replace the battery.
- Please properly dispose of used batteries according to the local garbage classification and recycling policy.
Instruction
Channels & Groups Togalina Number of Channels Setting Number of Groups Setting Channel in Group Setting Note: Channel in arouns setting is under GROUP 1-6
Check the Channels in Groups
Note: LCD will show “EC” if there is no detailed channel.
Prohibit Dual-key Operation
Repeat the above, dual-key operation activated
Note: When the dual-key operation is prohibited, these programming
setting functions are not allowed, such as limits set
Position Percent Setting
Note: All the shades under the same group will run to the same position
after the percent setting.
For other operations, please refer to the motor operation instruction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>