VISUAL COMFORT KS 5070 Walker Medium Two Tier Chandelier Instruction Manual
- June 4, 2024
- VISUAL COMFORT
Table of Contents
ASSEMBLY INSTRUCTIONS
Walker Medium Two Tier Chandelier
Item # KS 5070
NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect items and contents carefully. If any damage or defect is found, do not install it. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver
Slotted Screwdriver
Wire Cutters
Wire Strippers
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from the canopy (G) by removing the collar ring (H).
-
Install mounting plate (B) to the junction box and secure with mounting screws (E).
-
Feed fixture wires through column (L) and rod (I), connect together then connect to fixture body (J).
-
Continue feeding wires through collar ring (H), canopy (G) and top rod (F).
-
Holding fixture upright, slide collar ring (H) and canopy (G) down and rest on column (L). Then connect top rod (H) to middle rod (I).
NOTE: Slide components down slowly to avoid damage. -
Hang fixture swivel ball (M) to the center of mounting plate (B) and secure with set screw (C) using provided wrench.
-
Cut excess wires, being sure to leave enough to reach the junction box.
-
Separate two sides of the molded wire, and strip insulation on each 5/8″.
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded. -
Connect the fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
-
Connect the fixture hot wire (black) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck them into the junction box.
-
Install canopy (G) to mounting plate (B) and secure with collar ring (H).
-
Place shades (K) onto the sockets.
-
Install light bulb into the socket.
Care Instructions: Clean only with a soft dry cloth or feather duster. Do Not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>