LAMPEHUSET Deer Wall Lamp Nature Instructions
- June 4, 2024
- LAMPEHUSET
Table of Contents
LAMPEHUSET Deer Wall Lamp Nature
USE INSTRUCTIONS
- Use only LED bulbs.
- If you notice that the cable is damaged, stop using it and contact the manufacturer.
- Do not place the lamp directly next to the light sources (radiator, fireplace).
- Over time, slight changes in wood may occur.
- This is due to its natural adaptation to the conditions.
- Thelampshouldbecleanedwithadrycloth.
Always ensure that the main power supply is switched off before you install or change a light bulb. If the lamp was on, the light bulb and lamp part may be to heat. Wait for a little before you start changing the light bulb.
ASSEMBLING
Minimum distance to a combustible surface to prevent overheating
- Assembly and installation of the lamp can only be carried out by skilled persons.
- Before assembly, always ensure that the main power supply is switched off and secured against being turned on again.
- If you find that the power cord is damaged, discontinue use and contact the manufacturer or a qualified electrician.
- Lighting fixtures may only be used according to their intended use (ie indoor lighting must not be used outdoors).
- Do not place the lamp directly next to heat sources (heater, fireplace).
- The tree’s color shades can change to a small, insignificant degree over time. This is due to the wood’s natural adaptation to the conditions.
- The lamp must be cleaned with a dry cloth.
- The manufacturer is not responsible for damage caused by incorrect use or assembly.
- Do not hang the lamp too low. It must be out of the child’s reach for it not to be torn down.
Screw firmly, but “with a fine hand” Umbra key 5
Use the correct mounting system for the location you have chosen for installation.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>