UNBRANDED Mirroryywy-10 Wall Mount Vertical Dimmable LED Bathroom Vanity Mirror Installation Guide
- June 10, 2024
- UNBRANDED
Table of Contents
Get Your Home a Pro Choice INSTALLATION MANUAL
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical furnishing, basic precautions should always be
followed, including the following:
WARNING:To reduce the risk of burns,fire,electric shock or injury to
persons. Use this furnishing only for its intended use as described in these
instructions. Do not use attachments not recommended by the manufacturer.
Never drop or insert any object into any opening.Do not use outdoors.
WARNING: Risk of electric shock. Connect this furnishing to a properly
grounded circuit only. See grounding instructions.
CAUTION: Maximum shelf load 34lbs/15.4kg
ELECTRIC CONNECTIONS
ALL WIRING SHOULD BE DONE BY A QUALIFIED LICENCED ELECTRICIAN.
WARNING: Shut off power before wiring the cabinet.
Requires 120 VAC 20 Amp GFI protected Circuit.
GROUNDING INSTRUCTIONS:
CAUTION: This product must be connected to a grounded metal permanent
wiring system or an equipment-grounding conductor must be run with the circuit
conductors and connected to the equipment grounding terminal or lead on the
product.
WARNING: An Electrical option cabinet must be wired to a 20 Amp GFI
(Ground · Fault Interrupter) protected circuit when used in bathrooms and all
other locations required by the National Electric Code.
HARDWARE AND TOOLS
HARDWARE LIST
ITEM | REFERENCE IMAGE | NAME | QTY |
---|---|---|---|
1 | Screw ST4*35 | 2 | |
2 | Wall Anchor | 2 |
Step 1
Level and mark the mirror’s location on the wall.
Connect the wire to Junction Box inside the wall.
Step 2
Use the tape measure the height, and draw the horizontal ,line and the
vertical line of the wash-basin. Measure the distance of the mirror hole, and
mark the hole place on the wall.
Step 3
Drill and insert the Wall Anchor Drive in the screw cross the bottom support.
Step 4
Align the holes of the mirror with the screws and hang them to complete the
installation
After power on, the button shows blue and it is in waitng state ”
Click the bottom to make the light gradually dims
Click the buttom again and the light gradually brightens
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>