bopmen STAR 10 Disco Sparkling Wireless Karaoke Microphone User Manual
- June 10, 2024
- bopmen
Table of Contents
bopmen STAR 10 Disco Sparkling Wireless Karaoke Microphone
PARTS
- Speaker (Left & Right side)
- Microphone
- Control panel
- Handle (Metal)
- Voice-control disco light
Operating Guide
To ensure a better sound effect in Bluetooth mode, please click the Bluetooth settings on the device and synchronize the microphone volume with the device volume.
On/Off Button
Long press this button for 3 seconds to turn on/off the karaoke microphone.
Play/Pause Button
When the microphone is on, press the button to play or pause.
Microphone Volume Control Button
When the karaoke microphone is turned on, press the button, and the volume
loops in maximum-minimum-off modes by default.
Accompaniment Mode On/Off Button
Long press the button for 2 seconds when the karaoke microphone is turned on
under TF card mode.
REVERB
Reverberation On/Off Button
Switched on by default when the karaoke microphone is turned on; turn on/off
by pressing this button.
Bluetooth & TF Card Mode Button
Bluetooth mode is turned on by default when the karaoke microphone is switched
on and automatically switches to TF card mode after a TF card is inserted.
Once a TF card is inserted, long press this button for 2 seconds to switch to
Bluetooth mode.
Operating Guide
Disco Light Control Loop
Default maximum brightness when the karaoke microphone is turned on, press
this button to adjust the 3 brightness modes or turn it off.
Dual Pairing Button
Long press this button for 2 seconds to connect or disconnect in Bluetooth
mode.
Note: There will be a prompt tone“LINK CONNECTED” once dual pairing is
completed. Bluetooth pairing selection needs to be done again on the
cellphone/device and choose either of the two options.
TONE
Voice Change Button
The original voice mode is turned on by default. Press this button to switch
from male to female, female to male, animated and monster voice modes.
Volume Up Button
The default volume is the maximum level when the karaoke microphone is turned
on. There are 8 volume levels, press this button to adjust the volume. A beep
will sound when the maximum volume limit is reached.
Volume Down Button
Press to adjust the volume level. When it reaches the minimum volume level,
press again, and a beep will sound.
- Previous Song: Press the Prev Song button.
- Next Song: Press the Next Song button.
- Indicator
- The indicator flashes in light blue when the karaoke microphone is turned on and set on
- Bluetooth pairing mode and the light is always on once pairing has been completed.
- It flashes in red light when the battery is low and the red light is always on during charging.
- The red light turns off when the microphone is fully charged.
- The blue light is always on in TF card mode.
3.5mm Earphone Jack / Built-in Reset Button
When the karaoke microphone crashes, insert a sharp object into the hole to
reset it.
- TF Card Slot
- USB-C Charging Port
Specifications
- Bluetooth: 5.2
- Rated Power: 5 W
- Microphone: Supercardioid Dynamic
- Microphone Sensitivity: -52 dB
- Microphone Maximum Sound Pressure: 115 dB
- Speaker Frequency Response: 20 Hz – 20 kHz
- Wireless Signal Distance: 10 m
- Battery Capacity: 1800 mAh
- Battery Life: 4-5 hours
- Charging Time: 2-3 hours
- Charging Power: DC 5 V 1 A
- Dimensions: 2798697 mm
Package Contents
- Microphone speaker *1
- 50cm USB C-A cable *1
- User manual *1
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet the general RF exposure statement.
The device can be used in portable exposure conditions without restriction
Limited Warranty
Our friendly customer service team is ready and waiting to help. Here is how we can connect:
http://www.bopmen.com. info@bopmen.com.
UK REP: JunBright Ltd
- Add.: 51 Chalton Street London,
- England, NW1 1HY
- Tel.: +4407561533299
- E-Mail: yldyx112@outlook.com.
US Agent
- TRANS-PAC CHINA LLC
- Add.: 3715 S 182nd Street, C120
- Seatac, WA 98188-9993, US
- Tel.: +1 818-818-0538
- Email: lisaleeinchina@gmail.com.
C&E Connection E-Commerce (DE) GmbH Add.: Zum Linnegraben 20, 65933, Frankfurt am Main, Germany E-Mail: info@ce-connection.de.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>