PNI M200 Gel and Moto Batteries User Manual
- June 10, 2024
- PNI
Table of Contents
PNI M200 Gel and Moto Batteries
Special warnings
To use the device safely, observe the following indications:
- Do not use the charger in conditions of very high supply voltage.
- Do not try to open the charger case. Call an authorized service for diagnosis.
- Use only valid batteries. The use of non-functional, damaged, worn, excessively discharged batteries can lead to irreparable failure of the charger.
- Use the charger only after checking the connection and charging rules provided by the battery manufacturer and the compatibility between the battery and the charger. Incorrect operation can endanger the battery, the charger and your safety.
- Do not short-circuit the wires/terminals. The pliers must be tight on the terminals. Do not simultaneously touch both battery terminals or the wires connected to them.
- Avoid spilling or boiling excess electrolytic liquid. The electrolyte is corrosive to metal and represents a short-circuit hazard.
- Check the charging status regularly. If you suspect an anomaly or a charging time longer than 12 hours, disconnect and check the battery parameters at an authorized service. A damaged battery can no longer be charged to 100%.
General characteristics
The PNI M200 rectifier charger provides intelligent 3-stage charging for 12V
lead-acid and lead-gel batteries with reduced capacities, namely, a maximum of
20 Amps. In general, these accumulators are used either in the motorcycle
field, or for powering electronic equipment such as UPS, burglary systems or
for powering small consumers.
PNI M200 has a high degree of safety, being equipped with protections for:
reverse connection polarity, short circuit, overvoltage during charging
Instructions for use
- Connect the RED pliers to the (+) PLUS terminal and the BLACK pliers to the (-) MINUS terminal.
- Connect the charger to the 230 VAC power source.
- The indicator LED lights up red, confirming the start of the charging stage.
- After the charging is complete, the LED turns green and the charger goes into maintenance mode (Float).
- Disconnect the charger first from the 230 VAC power source and then from the battery, removing the black clips and the red clips.
Charging voltage
| Charging max. current| Float voltage
---|---|---
12V – 14.5V 2A| 2 A|
13.7V 0.2A
EU Simplified Declaration of Conformity
SC ONLINESHOP SRL declares that Battery charger PNI M200 complies with the
Directive EMC 2014/30/EU and LVD 2014/35/EU. The full text of the EU
declaration of conformity is available at the following Internet address:
https://www.mypni.eu/products/6273/download/certifications
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>