beckett 7207210 Small Container Fountain Pump Kit Instruction Manual

beckett 7207210 Small Container Fountain Pump Kit

Product Information

The product is a water pump with various nozzles, including a trumpet nozzle, lower nozzle, and water bell nozzle. It comes with a filter housing, foam filter, and adaptor for easy installation. The pump should only be operated when submerged in water and should be maintained regularly to ensure proper water flow. The power cord is not replaceable and should not be used to lift the pump. The product comes with a limited warranty.

Product Usage Instructions

1. Connect the adaptor to the pump’s discharge.
2. Push the pump onto the mounting plate’s 4 protruding tabs.
3. Slip the foam filter over the pump, aligning the slit with the power cord.
4. Place the filter housing over the foam filter until it snaps in place, aligning the top hole with the adaptor and the bottom opening with the power cord.
5. Push the extension tube all the way onto the adaptor.
6. Push the lower nozzle onto the top part of the extension.
7. Choose one nozzle (trumpet or water bell) and twist it inside the lower nozzle until fairly snug but not tight.
8. Add water to the container to the approximate height shown and plug in the pump. Slowly loosen the nozzle by turning it to the left until you receive the desired water shape.
9. If using the water bell nozzle, fill your container or sealed flower pot to the approximate height shown. Experiment with different water heights to find your preference for water shapes from your chosen nozzle.

Maintenance

If you experience a decline in water flow, it may signal low water or a dirty pump and filter block. Rinse out the foam filter block and pump with fresh water and reinstall. To clean the pump, remove the front plate and the impeller. Use a small brush stream of water to remove any debris.

Precautions

• Unplug the pump prior to handling.
• The pump should only be operated submerged in water.
• Dry operation of the pump could result in damage.
• The power cord is not replaceable and should not be used to lift the pump.
• If the power cord becomes damaged, discard the pump.

Warning

Refer to the product manual for safety information regarding the GFCI, drip loop, and grounding pin.

Limited Warranty

The product comes with a limited warranty for defects in material and workmanship. The warranty period begins on the date of purchase by the original purchaser.

WATER GARDEN CONTAINER KIT

Beckett pumps are carefully i nspected and tested to ensure both safety and operating performance for pond and fountain applications. However, failure to follow the instructions and warnings in this manual may result in pump damage and/or serious injury. Be sure to read and save this manual for future reference.

DISPLAY OF PARTS

MAINTENANCE

• A decline in water flow may signal low water or a dirty pump and filter block. Rinse out the foam filter block and pump with fresh water and reinstall.
• To clean the pump, remove the front plate and the impeller. Use a small brush or stream of water to remove any debris.

PRECAUTIONS

• As a normal safeguard, unplug the pump prior to handling.
• The pump should be operated submerged in water only. Dry operation of the pump could result in damage.
• The power cord is not replaceable and should not be used to lift the pump. If the power cord becomes damaged, discard the pump.

STEP 1
Connect the Adaptor to the Pump’s Discharge.

STEP 2
With the 4 holes, that the rubber feet were, push the Pump onto the Mounting Plate’s 4 protruding tabs, as shown.

STEP 3
Slip the Foam Filter over the pump. The slit in the Foam is to line up with the Power Cord.

STEP 4
Place the Filter Housing over the Foam Filter until it snaps in place. Line up the Housing top hole to fit over the Adapter and the back, bottom opening fits over the Power Cord.

STEP 5

Push the Extension Tube all the way onto the Adaptor.

STEP 6
Push the Lower Nozzle onto the top part of the Extension.

STEP 7
Choose one Nozzle, Trumpet or Water Bell, and twist inside Lower Nozzle until fairly snug, but not tight.

STEP 8

Now you are ready to place the Assembly in the center of your container and add water!

WARNING

Please refer to below.

• Trumpet Nozzle
• Water Bell Nozzle

STEP 9

• Add water to the approximate height shown.
• Plug the pump in. Please see the Warning below.
• Slowly loosen the nozzle by turning it to the left or Counter Clock Wise. Stop when you receive the desired water shape.

Fill your container or Sealed Flower Pot to the approximate height shown. The various water heights give you different water shapes from the nozzle you have chosen to use. Experiment to find your preference!

WARNING
The National Electric Code requires that a Ground Fault Circuit Interrupter be used. GFCI-type electrical outlets are commonly found at most hardware and home center stores. To prevent water from running down the cord into the electrical outlet, the cord should be shaped into a loop below the electrical outlet, to form a “drip loop”. This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly grounded, grounding- type receptacle. The grounding pin of the plug should never be removed. The pump should be operated only at the voltage shown on the pump label. Operate pump only in fresh water at temperatures of less than 86ºF as noted in the warranty.

LIMITED WARRANTY

Each Beckett Corporation (“Beckett”) product is warranted to be free from defects in material and workmanship for the applicable Warranty Period (herein so called) set forth below. The Warranty Period for each product commences on the date of purchase by the original purchaser. The Warranty Periods are as follows:

Product Type or Name Warranty Period

• Pump Models: Liner Material:
• FR Series, DP800-1800, G Series, FC Series ………… 2 Years 35 mil PVC……………………………20 Years
• BK17/22 Series …………………………………. 2 Years 40 mil EPDM…………………………… 20 Years
• Other Pump Models …………………………………..1 Year 20 mil PVC……………………………15 Years
• Pre-Formed Poly Ponds………………………..………15 Years UV9/UV13 Filter…………………………….. 1 Year
• Waterfall Weir & Skimmer………………………..………. 5 Years

APPLICATION: The warranty covers only properly installed and maintained Beckett products and is limited to the application at normal temperatures 32º F to 86º F, (0º C to 30º C) pumping fluids with a specific gravity up to 1.1 and with a pH range of 5 to 9 (freshwater). Other liquid applications and extreme temperature uses must be approved in advance by Beckett. The warranty does not apply to or cover damages or defects caused by external causes, including, but not limited to, improper or faulty installation or unauthorized modification, lightning, electrical surges, abuse, misuse or abnormal use or misapplication, including use in a manner inconsistent with the product’s intended function. The purchaser is responsible for determining the suitability of the product for its intended use. If products are damaged in transit, a claim should be filed with the carrier.

REMEDY: If there has been a failure to conform to the warranty, Beckett will, at Beckett’s option, repair, replace or issue a credit or refund for the particular nonconforming product or part. Repair, replacement, credit or refund, at Beckett’s option, is the exclusive remedy in the event of a failure to conform to the warranty. Warranty claims must be made within 3 months after the expiration of the applicable Warranty Period.
ADMINISTRATION: Warranty claims must be made by calling Beckett Corporation, Customer Service Dept., telephone 866-466-4319, or by emailing CustomerService@BeckettUS.com. Proof of purchase is required, and a shipping and handling fee applies to all warranty replacements.

INSTALLATION, REMOVAL AND/OR SHIPPING CHARGES: The warranty does not cover any costs associated with the installation, removal or shipping of products subject to warranty claims.
DISCLAIMER AND LIMITATION: THE EXPRESS WARRANTY AND REMEDIES SET FORTH ABOVE ARE EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES AND REMEDIES, WHETHER ORAL OR WRITTEN, EXPRESS OR IMPLIED. TO THE FULL EXTENT PERMITTED BY LAW, BECKETT EXPRESSLY DISCLAIMS ANY AND ALL IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IF IMPLIED WARRANTIES CANNOT BE DISCLAIMED, ALL SUCH IMPLIED WARRANTIES ARE LIMITED TO THE DURATION OF THE APPLICABLE EXPRESS WARRANTY. BECKETT DOES NOT ACCEPT LIABILITY BEYOND THE REMEDIES EXPRESSLY SET FORTH IN THIS WARRANTY. IN NO EVENT SHALL BECKETT BE LIABLE OR RESPONSIBLE FOR INCIDENTAL
OR CONSEQUENTIAL DAMAGES. BECKETT’S AGGREGATE LIABILITY UNDER THIS WARRANTY OR WITH RESPECT TO ANY PRODUCT COVERED HEREBY, UNDER ANY LEGAL THEORY, SHALL NOT EXCEED THE PURCHASE PRICE PAID FOR THE NONCONFORMING PRODUCT. THE LIMITATIONS CONTAINED IN THIS PARAGRAPH SHALL NOT APPLY TO INJURY TO THE PERSON. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES OR EXCLUSIONS OR LIMITATIONS ON THE DURATION OF AN IMPLIED
WARRANTY, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER RIGHTS THAT VARY FROM STATE TO STATE.
APPLICABLE LAW: THE TERMS AND CONDITIONS EXPRESSED HEREIN SHALL BE CONSTRUED AND GOVERNED IN ACCORDANCE WITH THE LAWS OF THE STATE OF TEXAS.

• © 2023 Beckett Corporation
• 3250 Skyway Circle N.
• Irving TX 75038www.BeckettUS.com
• Toll-Free: 1-866-466-4319

References

• Beckett Corp - Pumps You Can Trust

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>