VENTURE LIGHTING AK0014 LED Temporary Light Fixture User Manual
- June 11, 2024
- VENTURE LIGHTING
Table of Contents
VENTURE LIGHTING AK0014 LED Temporary Light Fixture
Product Information
The product is a lighting fixture manufactured by Venture Lighting. The user manual provides instructions for installation and usage of the product. The product comes with two figures, Figure 1 and Figure 2, to aid in the installation process. In case of any concerns or queries, customers can contact Venture Lighting’s customer service at 800-451-2606 or visit VentureLighting.com.
Product Usage Instructions
Before beginning the installation process, customers are advised to read the warning mentioned in the manual. It is crucial to follow all installation instructions carefully to ensure safe and proper usage of the product.
Product Installation Instructions
- Follow the warning mentioned in the manual before beginning the installation process.
- Refer to Figure 1 to identify the parts and components of the lighting fixture.
- Install the lighting fixture as per the instructions provided in the manual.
- Refer to Figure 2 to ensure that all components have been installed correctly.
- Test the lighting fixture to ensure it is working correctly.
- If there are any concerns or queries during the installation process, contact Venture Lighting’s customer service at 800-451-2606 or visit VentureLighting.com.
Before You Begin
Read These Instructions Completely and Carefully.
WARNING: Risk of electric shock
- Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance. Contact a qualified electrician for installation.
- Venture Lighting’s LED Temporary Light Fixture requires 120V 60Hz input voltage. The installer is responsible to determine whether the proper voltage is run to the luminaire being installed/serviced.
- Ensure the electrical receptacle is properly grounded.
- Venture Lighting’s LED Temporary Light Fixture is IP64 rated.
- This device is not intended for use with emergency exits.
- This device is not intended for use with dimmers.
- MIN 75°C supply conductor must be used.
- This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Installation Instructions
- STEP 1: Disconnect power from the luminaire and follow proper lockout/tagout procedures before beginning installation or maintenance.
- STEP 2: Screw the hook onto the top of the fixture. (Figure 1)
- STEP 3: Hang the fixture to a ceiling hook or similar. (Figure 2)
- STEP 4: Connect the plug into a 120V 60Hz receptacle.
- STEP 5: Add additional fixtures by plugging into previous fixture’s receptacle.
- STEP 6: Power can be restored to the system.
CONTACT
- 800-451-2606
- 6675 Parkland Blvd., Suite 100 Solon, Ohio 44139 USA
- E-mail: Venture_Lighting@VentureLighting.com
- VentureLighting.com
© 2022 Venture Lighting International
Venture Lighting is a registered trademark of Venture Lighting International.