ECCOTEMP i12 Water Heater Owner’s Manual

June 11, 2024
Eccotemp

ECCOTEMP i12 Water Heater

i12 Water Heater

Cleaning the Water Filter

HOW TO CLEAN THE WATER FILTER:
  1. Make sure the unit is OFF and the electrical power supply
  2. has been disconnected.
  3. Turn the water supply OFF to the heater.
  4. Disconnect the water source from the water inlet.
  5. Use a screw driver and gently remove the filter from inside the water inlet.
  6. To remove severe dust, use a soft brush and wash with running water.
  7. Return the filter to the water heater inlet pipe and reconnect your water supply.
  8. Turn the electrical power supply and cold water supply ON to the water heater.
    Cleaning the Water Filter

Extended Shut-Down

If the water heater is to remain idle for an extended period of time, the power and water to the appliance should be turned off.

The water heater and piping should be drained if they might be subjected to freezing temperatures.

After a long shut-down period, the water heater’s operation and controls should be checked by qualified service personnel.

Draining your Water Heater

When the temperature falls below 32°F, water in your plumbing system or water heater can turn to ice and then expand causing damage to the water heater. This damage is not covered under your manufacturer’s warranty. If these conditions are anticipated, please drain the water heater as follows to help but not guarantee from freezing. Below are instructions for draining water out of the water heater.

  1. Close the gas shut-off valve(s).
  2. Close the water shut-off valve.
  3. Turn the on/off switch to the OFF position and disconnect breaker at least 10 seconds after step #1.
  4. Open drain valve.
  5. Open all hot water faucets. Before proceeding to the next step, make sure that COLD water is coming out of all hot water faucets.
  6. To put the water heater back into operation after draining, follow the steps below.
  7. Reinstall the water filter. Close the hot water outlet drain valve.
  8. Open the water shut-off valve and close again after making sure that water comes out from hot water faucets. (This step is to remove air from the water lines).
  9. Reconnect the breaker and turn the on/off switch to the ON position, fully open the gas shut-off valve and the water shut-off valve.

NOTICE: The water heater may not operate unless the above procedure is followed correctly.

PLEASE NOTE: i12 IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE. PLEASE VISIT WWW.ECCOTEMP.COM/SUPPORT FOR MORE INFORMATION.

Phone:866-356-1992 I Email: Support@eccotemp.com I Address: 315 -A Industrial RD Summerville, SC 29483

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals