turbionaire Dot 35 Kitchen Cooker Hood Instruction Manual

turbionaire Dot 35 Kitchen Cooker Hood

SAFETY INSTRUCTIONS

• Thank you for purchasing this cooker hood. Please read the instruction manual carefully before you use the cooker hood, and keep it in a safe place.
• The installation work must be carried out by a qualified electrician or competent person. Before you use the cooker hood, make sure that the voltage (V) and the frequency (Hz) indicated on the cooker hood are exactly the same as the voltage (V) and the frequency (Hz) in your home.
• The manufacturer and the agent will not bear any responsibility for the damage caused by inappropriate installation and usage.
• Never let children operate the cooker hood.
• The cooker hood is for home use only. It is not suitable for barbecues, Roast shop and commercial purposes.
• The cooker hood and its filter mesh should be cleaned regularly in order to keep it in good working order.
• Before cleaning, switch the power off at the main supply.
• Clean the cooker hood according to the instruction manual and keep the cooker hood from the danger of burning.
• Prohibit putting the cooker hood by fire.
• If there is any fault with the appliance, please call the service department to request a service engineer.
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
• The instructions shall state the substance of the following: there shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).
• Do not flambé under the range hood. Accessible parts may become hot when used with cooking appliances.

Important Hints on Installation

• The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).
• Regulations concerning the discharge of air have to be fulfilled.

Important notes about the extraction mode

WARNING
Risk of poisoning from exhaust gases sucked back. Never operate the device in extraction mode simultaneously with an open flue appliance when there is not adequate airflow guaranteed.

Open fl ue combustion equipment (for example, gas, oil, wood or coal-fi red heaters, tanklesswater heaters, water heaters) pulls combustion air from the room and runs it through an exhaust pipe or chimney to the outside. In the extraction mode, indoor air is removed from the kitchen and the adjacent rooms – without suffi cient air intake this creates a vacuum. Toxic gases from the chimney or extraction fl ue can thereby be sucked back into the living spaces.

• Always ensure that a suffi cient supply of fresh air is guaranteed and that the air can circulate.
• An air supply / extractor box alone does not ensure compliance with the limit value.

Safe operation is only possible when the negative pressure in the room where the appliance is located does not exceed 4 Pa (0.04 mbar). This can be achieved when the air required for combustion can fl ow through openings that are not closable, for example in doors, windows, in conjunction with an air supply/ extractor box or through other technical measures. In any case, consult a qualifi ed chimney sweep who can assess the entire ventilation of your house and propose appropriate measures for adequate ventilation.

If the hood is used exclusively in the recirculation mode, unrestricted operation is possible.

WARNING
Fire hazard from flying sparks. Only install equipment on a fi replace for solid fuels (for example, wood or coal), if a closed, non-removable cover is available.

DIMENSIONS (mm)

Model No.: DOT 35 Island Black – Product Code: DOT35IB

INSTALLATION (Dot 35 Island Black)

Note: When the range hood and appliance supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must be not exceed 4 Pa (4 x 10-5 Bar).

Required minimum distance hood to

Ceramic-glass rings/hotplates 65 cm
Gas cooker 75 cm
Coal / oil / stove wood firing 85 cm

Installation Steps

Note: Do not connect the power cable until the installation is complete! Get a second person to help you with the installation.

1. Remove the screws ST4.0*8 (2pcs) on the upper chimney
   

2. Pull down the upper chimney.
   

3. Remove the M5x12 screws (4pcs) from the angle bars ,release the ceiling fixer for later installation.
   

4. Remove the M5 screws (4pcs) and M5 nuts (4pcs) from the angle bars and adjust the angle bars to a suitable height.
   

5. When you have adjusted the upper angle bars to a suitable height, connect the upper and lower angle bars with M5*12 screws and M5 nuts.
   

6. The upper and lower angle bars fixation completed.
   

7. Fix the ceiling plate in the ceiling.Use the ∅8 drill bit to drill holes in the ceiling. After drilling, use screws ST6 x 40 screws (6PCS) Or use M660 screws(4PCS) fixed ceiling plate
   
   NOTE: Use the M660 screws for cement ceilings. Use ST6*40 screws for wooden ceilings.

8. Position the air outlet at the installation opening and attach the hood to the ceiling with M5 x 12 screws (8PCS)
   

9. Slide the upper chimney up to the ceiling and fix it to the plate with ST4 x 8 screws (2pcs)
   

INSTALLATION (Dot 35 Wall Black)

Note: When the range hood and appliance supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must be not exceed 4 Pa (4 x 10-5 Bar).

Required minimum distance hood to

Ceramic-glass rings/hotplates 65 cm
Gas cooker 75 cm
Coal / oil / stove wood firing 85 cm

Installation Steps

Note: Do not connect the power cable until the installation is complete! Get a second person to help you with the installation.

1. Use a levelling instrument to measure the relative level of the surface of the hanging plate, and mark the positions for drilling holes.
   

2. Use M10 drill bit to open a hole at the mark, insert φ10 expansion rubber plug, fix the hanging plate with 4 pcs ST6.0x40 tapping screws .
   

3. Install well the tube or extension pipe into the hood. The outlet of the tube or the extension pipe can be back or up.
   

4. After the mounting plates are secured, mount the hood to it with 4 pcs screws M5x12,then installation is done.
   

5. Install the grease filter
   • Hold the grease filter and pull the locker on the grease filter outwards gentilly (img.1)
   
   • Insert the insert pin into the correct position, please refer to the image (img.2) Please note: the grease filter can be installed before or after the hood installed

Installation of the carbon filter – CODE: TCF1 (not included)

Technical data

| Value| Unit
---|---|---
Lighting efficiency class| A|
Air flow (3’rd speed/ 2’nd speed/ 1’st speed)| 650.5/ 581.4/ 367.6| m³/h
Electric power input| 126| W
Nominal power of the lighting system| 6| W
Sound power level – boost
Sound power level – high Sound power level – low| 67| dB
65| dB
48| dB
Energy Efficiency class| A++|
Annual Energy Consumption| 22.2| kWh/a
Connection diameter – minimum| 120| mm

FUNCTIONS

| Depress this button to turn off the motor
| Low – Depress this button to enter into low speed and again to turn off motor.
| Medium – Depress this button to enter into medium speed and again to turn off motor.
| High – Depress this button to enter into high speed and again to turn off motor.
| Turn on/off LED light.

Setting the booster

Depress the key untill the button flashes, the booster level is turned on, the appliance will now operate at the maximum level for 5 minutes. After 5 minutes a buzzer sound will be heard and the speed will go back to level 3 immediatly. To deactivate the Booster level before this time has elapsed, press the key briefly. The appliance will change to level 3.

Setting the timer

Depress the key and the key simultaneously untill the power button flashes ana a 5 minute countdown begins. After 5 minutes a buzzer sound will be heard, all the buttons light willbe off. The motor and the light will automatically switchoff. After this the hood will keep buzzing for 5 seconds if there is no other operation, the buzzer sound can be stopped by depressing any button during the buzzing. Users can stop this 5 minute countdown function at any time during the countdown by pressing the key and the key simultaneously again.

STAINLESS STEEL SURFACES CLEANING

To avoid damaging the stainless steel surface of your appliance

Always clean with:
Soft cloths, distilled or filtered water, as well as detergents specially made for stainless vsteel. Do not clean with:
Abrasive materials, cleaning powders, bleach and other chlorine-based products, ammoniacontaining glass cleaners, tap water especially if it tends to be hard water, oven cleaners.
Damage to stainless steel surfaces due to the use of improper cleaning substances is not covered by the warranty

TROUBLESHOOTING

and repair by qualified service personnel only.
The motor is damaged.
Both light and fan do not work| light bulb burn.| Replace the bulb with correct rating.
Power cord looses.| Plug in to the power supply again.
Serious Vibration of the unit| The fan blade is damaged.| Switch of the unit and repair by qualified service personnel only.
The fan motor is not fixed tightly.
The unit is not hung pro-perly on the bracket.| Take down the unit and check whether the bracket is in proper location.
Suction per-formance not good| Too long distance between the unit and the cooking plane| Readjust the distance to 65-75cm

HINTS ON DISPOSAL

According to the European waste regulation 2012/19/EU this symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailled information about recycling of this product, please contact your local council or your household waste disposal service.

Producer and Importer:
INTAX TRADING SRL 14B Ion Creangă Str., Otopeni, Ilfov, România
Tel (+40) 318 246 246. Fax (+40) 214 203 151
office@intaxtrading.com
www.intaxtrading.com

References

• Dehumidifiers, Portable Air Conditioners| Intax Trading
• Dehumidifiers Fans Air Conditioners| Turbionaire

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>