PetTec RST415729 Remote Spray Trainer User Manual

PetTec RST415729 Remote Spray Trainer

Here we go ….

Many thanks for choosing PetTec! The PetTec Remote Spray Trainer 4.0 is a new and effective aid for gently training your dog.

Safety Advice

To ensure safe operation of the PetTec Remote Spray Trainer 4.0, please adhere to the following safety advice.

• Our products are exclusively intended for dog training.
• Only intended for targeted training sessions (1-2hrs/day) and not for pro­longed use.
• Keep out of the reach of children.
• Do not allow your dog to swim while wearing the trainer. The weight or the Spraytion could affect the buoyancy of your dog.
• Do not disassemble at home.
• Protect from heavy rain.
• When filling, switching on and off, do not hold your head over the spray noz­zle to avoid a spray shock to the eyes.
• Protect trainer and spray from direct sunlight.
• Trainer is not suitable for controlling aggressive dogs.

Includes

• Trainer (receiver) with dog collar
• Remote control
• Hand strap for the remote control
• Charging cable for trainer and remote control
• Operation manual
• PetTec Spray 75ml

Overview of remote control

1. Antenna
2. LED status indicator
3. Blue LED backlit LC display
4. Intensity level adjustment (3 levels)
5. Signal buttons: sound and spray
6. Selection of the trainer (maximum two devices)
7. Charging port with rubberizedncover
8. Opening for hand strap

Overview of trainer

1. Dog collar
2. Spray nozzle
3. Charging port with rubberized cover 0 On/off button
4. Filling valve

Specifications

Features

• 300m range
• Up to 15 days battery life
• Additional sound signal
• 3 sprays of different strengths
• 1P65
• Expandable by additional collar*

Operation Guide

Remote control
The blue backlight on the display stays on for approximately 30 seconds after a button press. After that with no button press, the blue backlight shuts off first, and if no button is pressed within another five minutes, the display shuts off and the remote control goes into battery condervation mode. Pressing any button will turn the display back on.

Trainer
To turn the trainer on, press and hold the On/Off button until the green LED light comes on. Release the On/Off Button and if the trainer is in normal mode, the green LED will flash once every five seconds, indicating the trainer is on and ready to receive a signal from the remote control. To turn the trainer off, press and hold the On/Off button until the red LED light shuts off. (This takes approximately three seconds) After that release the On/Off button.
Note: To extend the life of the batteries, turn the trainer off when it is not in use.

How the remote control buttons work

1. Sprayt force selection
   The spray force is adjusted by one level each with the up and down keys.

2. Tone only button [upper button .. TONE”)
   Sends an audible tone to the trainer. No Spraytion is delivered.

3. Spray only button [middle button .. SPRAY”)
   Delivers Spray through the contact area on the remote control at the level shown on the digital display. When held down for ten consecutive seconds, the trainer will “time-out”, and Spray cannot be delivered for five seconds. You must release and press the button again after the five second time-out period, before additional Spray can be delivered.

4. Dog Toggle Switch [lower button .. 112″)
   The switch button allows the user to choose between two different trai­ners. Thus two trainers can be used with one remote control.

PetTec-Tipp:
To connect a second trainer, please set the toggle switch to 2 and switch on the trainer to be connected. The new trainer connects to the remote control by simultaneously pressing the tone signal and spray buttons.

Fit the collar
The trainer should be fitted so that the contact area presses firmly against the dog’s skin. When properly fitted, you should be able to fit a finger or two snug­ly in between the collar and the dog’s skin. When properly fitted, the trainer should not move on the dog. The best location for the trainer is directly under the dogs snout.

A loose fit can allow the trainer to move around on the dog’s neck. When this happens, the contact area may rub the skin and cause irritation. If the trainer is too tight, the dog may have difficulty breathing.

How to find the best Spray level
The PetTec Remote Spray Trainer 4.0 offers up to 3 different spray intensities. Level 1 is the weakest signal and level 3 the strongest. The level of spray inten­sity best suited for your dog depends on your dog’s temperament and threshold for spraying. Always start at the lowest level and work your way up.
The appropriate level can be found when the dog responds to the spray with a mild reaction, such as a tensing of the neck muscles. The spray level may vary depending on the training situation. When highly distracted, dogs will require a higher spray level.

How to maximize the distance
The unit has a 300 meter range. The range may vary depending on the way the remote control is held. Hold the remote control away from your body to receive the greatest range. For maximum signal strength, keep the devices properly charged.

LCD and LED indicator

• Indicates Spray intensity ranging from 1 – 3.
• Indicates the active trainer.
• Indicates battery’s power level. Note: The battery indicator will flash every second to indicate low battery.

Remote control LED indicator light function and response

Trainer indicator light function and response

Filling the Remote Spray Trainer 4.0

The Remote Spray Trainer 4.0 must be switched off for filling with spray. The filling nozzle must be placed vertically on the filling valve. When the filling noz­zle is correctly positioned, fill the trainer for 15 seconds with light pressure.
Note: To empty the tank of the Remote Spray Trainer 4.0 completely, press lightly on the filling valve with a screwdriver.

Charging the battery

1. Charge the unit before using it for the first time.
2. Do not charge the batteries near any flammable substances.
   Fully charge the batteries if the unit was stored without use for a period of 3 months or more.

Recharge the unit if:

1. The indicator light on the trainer is emitting a red color and flashes ra­pidly.
2. The 3 bar indicator on the remote control LCD shows just 1 bar.
3. The indicator light on the remote control or the trainer will not come on.
4. The indicator light on the remote control or the trainer comes on mo­mentarily when any of the mode buttons is pressed.

Note: The unit has a partial charge when 11 leaves our facility, upon receipt of the collar, be sure to give it a 4-hour initial charge before the first use.

Charging receiver and remote

Lift the rubber covers protecting the remote control / trainer charging jack. Connect the charger connectors to the remote control and the trainer charging jack, as shown below. Connect the USB port to the charging adapter. Plug the charger into a standard wall outlet. Charge the unit for 4 hours for the first charge. Recharges take only 2-3 hours. When charging is completed, remove the charger connector.
Note: The battery indicator on the remote control will scroll and the indicator light in steady red while charging; the battery indicator will become steady, and the LED indicator light flashes when fully charged. The indicator light on the trainer will be in steady red while charging and green light turns on when fully charged.

How to pair remote control and trainer
If your trainer does not beep when the TONE button of the remote control is pushed, or if you feel the trainer is not responding to the remote control, follow these steps to pair:

1. With the trainer off your pet, turn the trainer off. Restart, press and hold the On/Off button until the green LED light flashes every second on the trainer. This continues for 16 seconds, within which pairing should be completed.
2. Press and hold the TONE and SPRAY button of the remote control at the same time until the green LED light on the trainer flashes rapidly for 5 times, indicating pairing is completed.

Pairing second trainer

1. Set the toggle switch to 2.
2. Turn on the trainer of dog 2, press any mode buttons to verify function. If dog 2 trainer does not respond, pairing may be needed.
3. Repeat steps in .. How to pair remote control and trainer””.

Proper dog training

Proper training is the key to a harmonious coexistence between dog and owner. But we can often reach the limits of their abilities when training our four- leg­ged friends. The Remote Spray Trainer 4.0 is a gentle dog-training aid which helps to effectively discourage your pet from undesirable behaviors.
With the Remote Spray Trainer 4.0 you can intervene directly, even from a dis­tance, to immediately react to bad habits. Most dogs permanently adjust their behavior after just one or two uses of the trainer. Please note that the trainer is a training device and not a toy, and always should be used with care. So at this point we ask you to observe the following guidelines:

Before training

1. Be sure that your dog’s undesirable behavior is not a result of insufficient physical activity or health problems. In this case please do not use the Trainer, and seek professional advice.
2. Get your dog accustomed to the Trainer collar before you turn it on.
3. For safety, do not a low your dog to swim while wearing the Trainer. The collar’s weight or the spray function could hinder your dog’s ability to swim. If the Trainer gets wet, simply let it dry. After exposure to water, ne­ver open the rubber cover to the charging connector, to prevent moisture from getting into the Trainer.

During training

1. Immediately remove the trainer if your dog appears agitated!
2. Always use the trainer in a controlled manner. Just as with normal trai­ning, it helps to give clear commands. Your dog must first learn these to be able to react appropriately to them.
3. Train your dog for a maximum of 1-2 hours per day. Remove the trainer after each training session and turn it off.
4. Always reward your dog after a successful training session.

Customer support

Declaration of conformity
Stage10 GmbH hereby declares that the PetTec training device Remote Spray Trainer 4.0 described in this user manual complies with the Directive 2014/53/ EU.The full text of the EU declaration of conformity is available at the following Internet address: https://support.pettec.de/hc/de/sections/360003118719-Remote-Spray- Trainer-2-0

Declaration of conformity (see chapter “Declaration of confor­mity””!: This symbol indicates products that fulfil all applicable Community regulations in the European Economic Area.
This symbol certifies that the device·s electromagnetic interfe­rence is below the limit approved by the United States Federal Communications Commission.

Disposing

Disposing of the packaging
Dispose of the packaging sorted into single-type materials:

• Paperboard and cardboard for recycled paper
• Films in the recyclable material collection service

Disposing of the device
Applicable in the European Union and other European states with systems for the separate collection of reusable waste ma­terials.

Old devices must not be disposed to household waste!
If the Remote Spray Trainer 4.0 is no longer operational, every consumer is required by law to dispose of used devices separa­tely from household waste, e.g. at a collection point run by the communal authority/borough. This ensures that old devices are recycled in a professional manner and also rules out negative consequences for the environment. For this reason, electrical equipment is marked with the symbol shown here.

Manufacturer information and service
If you have questions regarding the PetTec Remote Spray Trainer 4.0 or if any problems occur during operation or similar, first contact the following body via e-mail: info@PetTec.de
PetTec is a trademark of Stage10 GmbH Oranienburger Str. 45
10117 Berlin
www.PetTec.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>