DEWHOT 30L Fan Forced Gas Geyser User Guide

DEWHOT 30L Fan Forced Gas Geyser

Product Information

The 30L Fan Forced Gas Geyser is a smart device that can be operated using WiFi. It allows you to control and monitor your water heater remotely using the Tuya Smart app. The geyser comes with a controller that needs to be connected to the water heater for proper functionality. The controller has a WiFi light indicator to show the status of the WiFi connection.

Product Usage Instructions

1. Search for “Tuya Smart” in your app store or scan the QR code provided in the user manual to download and install the app.
2. Ensure that your device is connected to WiFi and Bluetooth is enabled.
3. Connect the controller to the water heater using a cable. Switch on the geyser, and the WiFi light on the controller will start flashing.
4. Open the Tuya Smart app and click on “Add Device” or the “+” symbol located in the top right corner of the screen.
5. Select “Large Home Appliances” and then choose “Gas Water Heater” from the available options.
6. Sign into your WiFi network within the app.
7. Make sure the WiFi light on the controller is still flashing.
8. Once the connection is established, the WiFi light on the controller will remain on.
9. If the WiFi light indicates that it is off, there may be an error in the connection. Check your WiFi settings and try again.
10. To restart or reset the connection, press and hold the button on the controller for approximately 5 seconds until the WiFi light starts flashing again.

APP INSTALLATION

1. Search for “Tuya Smart” in your app store or scan the below QR code to download the app
2. Your device needs to be connect to WI-FI and your bluetooth needs to be switched on
3. Use a cable to connect the controller to the water heater. Switch on the geyser, and the WI-FI light on the controller will start flashing
4. Open the app and click “Add Device” or the “+” in the top right corner
5. Select “Large Home Appliances Click “Gas Water Heater”
6. Sign into your WI-FI
7. Make sure the light is flashing
8. Once connected the WI-FI light on the controller will always be on
9. If the WI-FI indicates that is off then there is error in the connection
10. To restart or reset the connection, press the button for around 5s until the WI-FI light starts flashing again.

APP FUNCTIONALITY

• Power button
  On/Off switch

• Status button
  Indicates if the geyser is heating or is not heating

• Temp Unit Conversion
  Allows you to switch between˚C and ˚F

• “-35+”
  Allows you to adjust your temperature

• Outlet Temp
  Shows the actual temperature of water

MODES

• High
  Setting temperature at 50˚C

• COMF
  Setting temperature at 45˚C

• Low
  Setting temperature at 37˚C

• User Setting Mode
  Setting your own temperature

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>