TIMEX T200 Strap Watch User Guide

: August 21, 2024
: Timex

Table of Contents

TIMEX T200 Strap Watch
Product Specifications
FAQs
FUNCTIONS
BASIC OPERATION
MODE® FEATURE
WATER RESISTANCE
BATTERY AND WARRANTY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TIMEX T200 Strap Watch

Product Specifications

Model: T200
Product Code: ENB-8-B-1054-01

FAQs

Q: How can I switch between time zones?
- A: In Time mode, press and hold START/LAP for 4 seconds to switch between time zones.

WARNING

INGESTION HAZARD: This product contains a button cell or coin battery.
DEATH or serious injury can occur if ingested.
A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
KEEP new and used batteries OUT OF REACH of CHILDREN
Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.

Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate.
Even used batteries may cause severe injury or death.
Call a local poison control center for treatment information.
Battery type: lithium metal, CR2016.
Nominal battery voltage: 3.0 V
Non-rechargeable batteries are not to be recharged.
Do not force discharge, recharge, disassemble, heat above 158°F (70ºC) or incinerate. Doing so may result in injury due to venting, leakage or explosion resulting in chemical burns.
Ensure the batteries are installed correctly according to polarity (+ and -).
Do not mix old and new batteries, different brands or types of batteries, such as alkaline, carbon zinc, or rechargeable batteries.
Remove and immediately recycle or dispose of batteries from equipment not used for an extended period of time according to local regulations.
Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children.

Please read instructions carefully to understand how to operate your Timex® watch. Your model may not have all of the features described in this booklet.

FUNCTIONS

Real-time calendar clock, Second time zone, Countdown timer, Daily/ weekday/weekend alarm, Hourly chime, 200 Lap Chronograph, Interval Timer, Review,INDIGLO® night-light with Night-Mode® Feature.

BASIC OPERATION

When setting, each button has a different function as indicated above. Watch face will indicate when button changes function.

TIME/DATE/HOURLY CHIME

In TIME mode, press and hold SET/RECALL. Time zone will flash.
To set, push + or – to select first or second time zone.
Press NEXT. Hour digits flash.
Press + or – to change hour including AM/PM. (Scroll through 12 hours to get to AM/PM).
Press NEXT. Minute digits flash.
Press + or – to change minutes.
Press NEXT. Second digits flash.
Press + or – to set seconds to zero.
Continue pattern to set month, day of month, year, 12-hour or 24-hour time display, MM.DD or DD.MM date format, turn hourly CHIME on/off, turn BEEP on/off. If you select BEEP on, a beep will sound every time you push a button (except INDIGLO®).
Press DONE to confirm and exit or NEXT to continue and set second time zone, if desired.
When in Time mode, press and hold START/LAP to “peek” at second time zone; hold for 4 seconds to switch time zones.

CHRONO

Press MODE until CHRONO appears.
Press and hold SET/RECALL.
The Display will read: FORMAT/SET, then select LAP/SPL or SPL/LAP options.
Press + or – to select desired format.
Press DONE to confirm and exit.
To use chrono, press START/LAP. Chrono continues to run even if you exit the mode.
Press STOP/RESET to stop chronograph from running OR while chrono is running, press START/LAP to take a split. Lap and split times will then be displayed in the format you selected. The lap number will alternate with the last two digits of the bottom line.

NOTES:

Lap and split times will appear frozen for 10 seconds. Press MODE to release the display and see running chrono.

INTERVAL TIMER

Single simple Interval Timer with four segments: Warm Up, Interval 1, Interval 2, Cool Down.

To set:

Press MODE until INTTMR appears.
Press SET/RECALL, wait for WARMUP to flash.
Press NEXT. Hour digits flash. Press + or – to change hours.
Press NEXT. Minute digits flash. Press + or – to change minutes.
Press NEXT. Second digits flash. Press + or – to set seconds.
Press NEXT to proceed to INT 1. Then follow steps 3-5 to set.
Complete setup of INT2 & COOL using steps 3-5.
Press NEXT to confirm and exit.
Press START/LAP to start Interval Timer.

NOTES:

When first countdown is complete, Timer proceeds to the next non-zero interval that is set.INDIGLO® night-light flashes and beep sounds between each interval.
If you set both Timers in Interval Timer to repeat, Timer will countdown both intervals and then repeat entire sequence.
Press and hold STOP/RESET to reset Interval Timer.

TIMER

Press MODE repeatedly until TIMER appears.
Press SET/RECALL. Hour digits flash.
Follow same pattern as setting TIME and ALARM to set hours, minutes, seconds, and select between REPEAT/AT END (timer counts down and then repeats) or STOP/AT END (the timer counts down and then stops).
Press DONE to confirm and exit.
Press START/LAP to start TIMER. Timer will continue to run even if you exit Timer mode. If REPEAT/END selected h will flash. If STOP/END selected H will flash.
An alarm melody will chime when the timer has reached zero or before it starts to count down again.
Press STOP/RESET to stop TIMER. Press again to reset to countdown time.

REVIEW

Press MODE until REVIEW displays.
Press START/LAP to select a workout to view, and then press SET to view the data for that workout.
Press + and – to scroll through the workout data.
Press SET to go back to the list of saved workouts.
Press MODE to exit.

NOTES:

Press and hold SET to clear workout memory.

ALARM

Setting the ALARM is similar to setting TIME.

Press MODE repeatedly until ALARM appears.
Press SET/RECALL to set alarm.
Hour digits flash. Press + or – to change hour.
Press NEXT. Minute digits flash. Press + or – to change minutes.
Press NEXT. If in 12-hour format, AM/PM flashes. Press + or – to change.
Press NEXT. Press + or – to select DAILY, WEEKDAYS OR WEEKENDS.
Press DONE to confirm and exit.
Press START/LAP or STOP/RESET to arm or disarm alarm. When disarmed, OFF will be displayed. When armed, the alarm clock icon will appear t.
The INDIGLO® night-light and alarm icon flashes and an alert sounds when the alarm goes off. Press any button to silence. A back up alarm will sound after five mintues if you don’t press any buttons.

MODE® FEATURE

INDIGLO® NIGHT-LIGHT/NIGHT MODE® FEATURE

Press INDIGLO® button to activate night-light. Electroluminescent technology used in INDIGLO® night-light illuminates entire watch face at night and in low light conditions. While the night-light is on pressing any button keeps it on for three seconds.

Press and hold INDIGLO® button for 4 seconds to activate NIGHT-MODE® feature. Moon icon will appear. Once activated, any button pushed will cause INDIGLO® night-light to stay on for 3 seconds. NIGHT-MODE® feature will stay activated for 8 hours or until deactivated by pressing and holding INDIGLO® button again for 4 seconds.

WATER RESISTANCE

If your watch is water-resistant, meter marking or ( ) is indicated.

*pounds per square inch absolute

WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER WATER.

Watch is water-resistant only as long as lens, push buttons and case remain intact…
Watch is not a diver watch and should not be used for diving…
Rinse watch with fresh water after exposure to salt water…