PAC LPHTY02 LocPRO Advanced T-Harness For Toyota Factory Radio with Non-Amplified System Instructions
- June 4, 2024
- PAC
Table of Contents
PAC LPHTY02 LocPRO Advanced T-Harness For Toyota Factory Radio with Non-
Amplified System
Wiring Connection Chart
(All Models)
MODELS:
- LPA-E4
- LPA2.4 / LPA2.2
- LPA1.4 / LPA1.2
Important Note: This harness is provided with an inline fuse installed. Please remove prior to installation and reinsert once finished. If your vehicle does not provide ACC source your harness will not have a”RED” wire to connect. It will use DC Offset to turn on as well as trigger the “REM OUT” on the LPA. On LPA-E4 there will be a jumper that you can move based on your application. This harness is designed to work on OEM NON-AMPLIFIED systems. Connect the RED BUTT Connector to the aftermarket system and turn on for your amplifiers.
Example Installation
– 4-Channel Amplifier – (HARNESS CUT REQUIRED)
- Cut the harness close as possible to the “CUT HERE AND INSULATE” label. You must insulate wires to prevent damage to OEM radio.
- The cut speaker wires will need to be connected to your aftermarket amplifier. (REFER TO LABEL ON HARNESS)
- Please refer to the chart on the first page for wiring your loose wires to your LPA.
- This harness is designed to work on OEM NON-AMPLIFIED systems.
– Mono Amplifier – (HARNESS CUT NOT REQUIRED)
- If using a 2-Channel input LPA use the front speaker wires and insulate the remaining front speaker wires.
- DO NOT CUT the speaker wires in between the “CUT HERE” Labels in order to keep the factory speakers functional.
- This harness is designed to work on OEM NON-AMPLIFIED systems.
© 2021 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global. PAC-audio.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>